PARKED CAR WEATHER GOT DOWN TO FREEZING NEXT DAY WOULDNT START.WAITED 3 WEEKS TIL IT WARMED UP.ITS GETTING FUEL AND FIRE BUT HAVE TO HOLD TO FLOOR JUST TO GET IT TO RUN,IT WONT REV UP RUNS FOR BOUT 15 SECS THEN DIES.TIMMING OK,NEW PLUGS,PLUGS WET WITH GAS AND GOT SPART.ITS AS IF IT ISNT GETTING ENOUGHT GAS.LOOSEN BOLT ON FUEL RAIL AND GAS GUSSED OUT.I KNOW ALL THE INJECTOR CCOULDNT HAVE WENT BAD ALL AT ONCE.STUMPED.NEED EXPERT ADVISE.
NEED HELP on 1993 Mazda MX-6
by shepster in New Castle, IN on February 16, 2011
1 answer 3 comments
ANSWER by mastertech6371 on February 16, 2011
do a compression test. look for all of them being low. from what you describe, if you have spark and fuel, you may have a timing belt issue. by the way, how did you check the timing?? roy
cant get it to run long to check. pulled cap and #1 plug and they line up tdc and belt not broke.i pull in drive and it was running next morning it was freezing out and wont start.now it is warm.acts as if it is not getting enough gas
COMMENT by Visitor on February 16, 2011
compression test are done without the motor running, just cranking. i would still start there and move forward. Roy
my gas was low when it wouldnt start so i added 2 gals,just talked to my neighbor and they had gotten bad gas and there truck did same thing they go where i go,they traded the truck of.if thats what it is what can i do
...money to check for the error codes if I dont have too. Any idea whats causing this..PLEASE I NEED HELP ON THIS ONE..AND THANK YOU
my car wont turn over at all.when you try to start it,the fan comes on and thats it like its in diagnostic mode.could ignition switch be bad? the car has bad tranny thats stuck in drive as soon as ...
I do have a Mazda MX6 2.5 V6 1997 MODEL. I had to replace my old motor with a import motor exact same as my old one. Ever sinse no results no spark on plugs. I did replace the distrubiter and cranc...
I cannot find a speed sensor for our 1993 Mazda MX6 need help
It has what looks like an extension cord hooked up to a plug that it's connected to the engine Block i was told it was there to warm up the oil if you live in a cold climate please help