I recently went out for about an hour to get some concrete and as I went to reverse into my drive way the car stalls out and would not start. I changed the fuel pump and I noticed that the wiring harness was frayed so I replaced it and then I tried to start it and nothing not even a hum from the fuel pump when I started it I also replaced the relay and still nothing I have no gas getting to the engine at all I recently bypassed the wiring harness and wired it to the battery and the pump comes on and it gets gas to the engine but still does not start. please I don't know what the heck is the problem................
my Chevy blazer will not start on 2000 Chevrolet Blazer
by crazzykid624 in Lehigh Acres, FL on April 18, 2013
1 answer 2 comments
ANSWER by pushrod on April 18, 2013
Check the fuel pump fuse? It is right in front of the relay!
COMMENT by crazzykid624 on April 18, 2013
its good but I recently ran pump directly to battery and pump came on gas got to engine but it will not turn over it cranks but just wont start
COMMENT by pushrod on April 19, 2013
GOT SPARK? TO THE PLUGS.
1999 chevy blazer failed emissions test because the check engine light did not come on when they started the engine..what could b...
When the problem started, It would turn over the starter but I would not hear the seatbelt noise. Try again and the seatbelt noise could be heard and it would start instantly. Over the next week i...
Chevy Blazer 1993 S-10 I've noticed when trying to start my truck, it takes several attempts to get the truck started. Once started, it runs rough. I've taken to a mechanic who says it could b...
Basically not firing when ignition is in start position but I have to let key return to on position and it fires so why isnt my ignition firing in start position