I changed the breather hose and lost where the extra little hose on it connects to. finally found where, and i then took off 2 wires to distributor cap for inspection. I put them back then car wouldnt start. I changed ignition coil, spark plugs,cap and rotor which were very bad condition, car still wont start,cranks but wont start. I noticed the engine fan stopped turning.Now im sitting for three weeks....help!!!!!!
Q&A
Ask Your Question1992 Mercedes-Benz 300CE
Question: My car wont start but only cranks, what can it be? i provided details on page.
-
Answer #1
sidnyt March 20, 2012, 09:53
Enthusiastall you do is replace the Crankshaft position sensor which is situated in in the back of your engin, then you problem is sorted out, i have done that my self and advised many who had joy
Flag ThisLike0 -
Reply
preech, March 20, 2012, 11:52RookieThank you for your response! sounds possible, i was told it maybe my ignition module which is a fortune for my module, but i'm not sure and don't want to save up to get that especially if its not the problem. there's no electricity reaching the ignition coil, i changed it and the cap and rotor and there's no spark in the wires. you still think its the crankshaft sensor?
Flag This -
Reply
sidnyt, March 20, 2012, 15:52Enthusiast100% CPS, it cost around $55.00 and you can fit it your self, it is a bit small place behind the engine, but i am sure you will manage
Flag This -
Reply
preech, March 20, 2012, 20:23ReplyRookieok thank you very much for the information i will try that!
Flag This
Answer Ranks
This week's top 10
| 1 globalhelper | 6 FREDDY BLUE |
| 2 pushrod | 7 csubak30 |
| 3 ziptie12 | 8 ebans777 |
| 4 ChevyASE | 9 gearhead89 |
| 5 wenyan | 10 corvairart |