my 1996 dodge avenger on 1996 Dodge Avenger

my timing belt broke it is a 24 vavle do i have any bent valves

by in Greenville, FL on December 14, 2010
2 answers
ANSWER by on December 14, 2010
very probable. the belt needs to be laid on the car and a compression test done to determine. Roy
ANSWER by on December 15, 2010
if its a non interference engine then you'll have no bent valves if its an interferance engine its likely you have terminal damage.
Related Items:
Where is the fuel pump kill switch located on a 1996 dodge avenger?
My car started overheating about two weeks ago and the interior heat stopped working. We thought it was the thermostat so we replaced it. While we were adding more antifreeze to the system, we noti...
96 Dodge Avenger 2.5 V6. The car ran fine but the water pump was bad. So I pulled it into the g...
A defective vehicle speed sensor can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors are also susceptible to corrosi...
it wont shift out of second. it run fine but just wont shift.