2006 Mitsubishi Galant Problem Reports

Newest 2006 Mitsubishi Galant Problem Reports

Report A Problem

The clutch may fail prematurely or cause a buzzing type noise from the dash area. It has been recommended by some that a high quality aftermarket replacement clutch may provide increased longevity over a clutch purchased from the dealer.

One or both side airbag modules may fail resulting in illumination of the airbag warning light. Side airbag modules determined to be faulty should be replaced.

There have been reports of airbags not deploying in the event of a frontal impact. Some claim that a shorted airbag wire harness can cause this to occur. Unfortunately there is no diagnoses that will isolate this problem other than fault codes stored in the airbag control module. Our technicians recommend to have any airbag light issues diagnosed and repaired in order to help ensure the airbags will deploy when needed.

The Check Engine Light may illuminate due to one or more engine vacuum leaks. Our technicians tell us these leaks can be caused by damage to seals and/or vacuum hoses as a result of to much ethanol content in the gasoline. Affected hoses and seals must be replaced to correct this concern.

The brake pedal may pulsate when the brakes are applied. This is most commonly caused by the front brake rotors warping. Resurfacing the affected rotors may correct the problem for the short term but replacement would generally considered a longer term solution.

A rattle type noise may develop from one of the exhaust heat shields. Replacement of the affected heat shield may be required to correct this issue.

It is not uncommon for the clear coat paint on black vehicles to develop white spots and begin peeling. In most cases Mitsubishi will not cover out of warranty repairs for this condition.

The drivers power seat may not adjust properly or develop a noise issue when adjusting. This is commonly caused by a damaged drive cable which will require replacement.

The Check Engine Light may illuminate with no fault confirmed. Our technicians tell us a powertrain control module (PCM) software update is available which may correct this concern.

The power windows may fail, often related to moisture inside the door. Affected components will need to be replaced. If possible some type of moisture protection could be added to try and prevent repeat failures.