1995 Mitsubishi Eclipse Problem Reports

Most Reported 1995 Mitsubishi Eclipse Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The brake pedal may pulsate when the brakes are applied. This is most commonly caused by the front brake rotors warping. Resurfacing the affected rotors may correct the problem for the short term but replacement would generally considered a longer term solution.

A rattle noise may be noted from the clutch area while the car is at idle. If the noise changes or goes away when the clutch is depressed the fault is commonly with the clutch disc springs. It has be reported that a revised clutch disc is available from Mitsubishi to correct this concern.

 

It is not uncommon for wheels on these vehicles to be very easily bent or otherwise damaged, often to the point of requiring replacement. This can happen even with no apparent damage to the tire.

There have been reports of airbags not deploying in the event of a frontal impact. Some claim that a shorted airbag wire harness can cause this to occur. Unfortunately there is no diagnoses that will isolate this problem other than fault codes stored in the airbag control module. Our technicians recommend to have any airbag light issues diagnosed and repaired in order to help ensure the airbags will deploy when needed.

The engine may stall or develop a rough idle with the Check Engine Light illuminated and fault code 15 stored in the ECU. Our technicians tell us that the engine electrical grounds are critical, all 5 should be inspected and cleaned as necessary. An additional ground lead kit is also available which can be installed to help correct this condition.

The front, lower ball joint may fail unexpectedly resulting in loss of vehicle control. Failed ball joints will require replacement. Our technicians recommend a complete inspection of related suspension components if this situation occurs. This should be done in order to determine if there is any other damage as a result of the ball joint failure.

Is not uncommon for one or more of the support brackets on the convertible top to bend requiring replacement.

The front, lower ball joint may fail unexpectedly resulting in loss of vehicle control. Failed ball joints will require replacement. Our technicians recommend a complete inspection of related suspension components if this situation occurs. This should be done in order to determine if there is any other damage as a result of the ball joint failure.