X

Mercury Villager Recalls

Models : Mercury Villager
Engine, October 25, 1996
Summary:THE FOUR RUBBER FUEL LINE CONNECTOR HOSES THAT ARE SUPPLIED TO FORD WITH THE FUEL TANK ASSEMBLY WERE IMPROPERLY MANUFACTURED. THESE HOSES CAN DEVELOP CRACKS OR SPLITS RESULTING IN FUEL LEAKAGE.
Models : Mercury Villager
Body, Interior & Misc., July 10, 1996
Summary:AN OUT-OF-SPECIFICATION CONDITION IN THE SEAT CABLE ROLLER PULLEY ASSEMBLY CAN ALLOW THE CABLE THAT CONNECTS THE SEAT ADJUST LEVER TO THE LATCH TO BE PINCHED IN THE ROLLER ASSEMBLY.
Models : Mercury Villager
Body, Interior & Misc., December 20, 1995
Summary:LEAVES AND OTHER FOREIGN MATERIAL CAN ENTER THROUGH THE COWL PANEL AIR INTAKE DURING OPERATION OF THE FRONT HEATER AND/OR AIR CONDITIONING SYSTEM RESULTING IN A BUILD-UP OF MATERIAL IN THE PLENUM. THIS CAN LEAD TO NOISE, ODORS, OR IN SOME CASES, IGNITION OF THESE MATERIALS.
Models : Mercury Villager
Body, Interior & Misc., October 7, 1994
Summary:THE WINDSHIELDS WERE MARKED WITH A "PROTOTYPE" DESIGNATION AND NOT MARKED AS REQUIRED BY FMVSS NO. 205, "GLAZING MATERIALS."
Models : Mercury Villager
Engine, December 24, 1992
Summary:FUEL FILLER HOSES MAY HAVE BEEN CUT PRIOR TO INSTALLATION BY A UTILITY KNIFE USED TO OPEN THE SHIPPING BOX.
Models : Mercury Villager
Brakes, September 29, 1992
Summary:THE SERVICE BRAKE MASTER CYLINDER WAS NOT PROPERLY ASSEMBLED OR COULD HAVE BEEN DAMAGED BY THE EVACUATION AND FILLING OF THE BRAKE SYSTEM AT THE ASSEMBLY PLANT.
Models : Mercury Villager
Body, Interior & Misc., September 29, 1992
Summary:ONE OR BOTH OF THE BOLTS SECURING THE AUTOMATIC SEAT BELT RESTRAINT SYSTEM TRACKS TO THE B-PILLARS WERE NOT ADEQUATELY TIGHTENED.