1999 Mercury Villager QuestionsRefine by vehicle
start agan untile you let it cool down again then it starts right up again it will run 10 min. shut off again
when every i turn the car off and put gas in the car the engine check light comes on after the machanic decodes the car. how should i run the car to reset the sencor after the work is done?
Hole in rear air condition tubing
I would fill up on Monday morning set my cruise control between 65 and 70 get on the highway and drive to work about an hour away. By Wednesday it is on empty and I have to refuel. I do the same thing with my moms van and I don't have to put fuel in it until Friday evening. My email is email@example.com. Thanks for your time.
enginr just stopped while driving.ive chacked several things and found theres no spark to plugs...any suggestions?im a fairly capable mechanic yet id like to get a direction to start with ...distribiuter?timing belt?
need to know where heater fanspeed resistor is located, my fan only runs on high speed not 2 and 3
need to know where the computer is location
I need a new complete rear axle,Ac Compressor,New Brakes,An Alignment.
Whats a price on getting the knock -sensor fixed? Thanks.
It idols rough when it is gear when stopped at red light or waiting in traffic. No check engine lights on
one code reader said cylender 4 misfire, so i changed plugs. still missed. my mechanics reader said random misfire, he said change wires, i did. still misses. is there a coil pack? should i look there?
please advise where the fuel filter is located on my 1999 villager estate van.
I WOULD LIKE TO KNOW WHAT THE REAR HEATER CONTROL VALVE CONTROLS? WHICH VENTS BLOW FROM THE REAR VALVE?IF THE VALVE IS BAD WILL THE DUCT BLOW COLD AIR OR NO AIR. DOES MY VAN HAVE A CLIMANT CONTROL SYSTEM?
Installed aftermarket Viper 350 alarm in car. Worked OK until door was opened when alarm was active. This blew smart entry control module. Headlights stayed on and horn blew.
Removed horn fuse. Removed negative cable to hush headlights.
Instead of door trigger used dome light as trigger for alarm.
Any ideas on what caused alarm to fry our control module
Replaced module since and everything works fine.
po300 is the code that i get what could it be