1997 Mercury Villager Questions
Answered 1997 Mercury Villager Questions
Ask a Question
just changed master cylinder, now rear wheel on driver side locking down. when i bleed the line will free wheel up but after driving a few miles will lock back down. Line look good what am i doing wrong?
It does not happen when col but especially when I get out on the highway it starts to happen. I have replaced a the fuel filter and and put gas additive in to clean the injectors and it did not help. What should I b...
My van will start some times but other times it has like a slow dragging sound I guess not sure rally how to describe it but that is as close as I can when I put it in park it will idel down and die most of the time t...
When your driving it don't shift right or idle right when you come to a stop
While i was driving got plenty of gas.
replaced compressor,dryer,cooling fan and runs fine now but when air is off and fan cuts on the temp gauge jumps from normal to 1st hot line...then cools back down...wondering if air in system.if so then where are bl...
its leaking and I don't use it
On two occasions in the last two weeks, my 97 villager simply would not start. I tried jumping it the first time, but no effect. When I turned the key, the startup lights on the dash, radio, heater fan, etc. all cam...
Drove it 4 miles and back went to leave again 20 mins later and it wouldn't turn over, all you heard was click click and fuel pump. Here's what I had done, checked relays and fuses and bought new battery's s still it ...
engine died , car bucked like downshift and would not restart but did not choke or starve for fuel it died suddenly no warning .....electrical ???what do you think
1997 mercury villager
Brake light comes on sometimes when turning right and goes off after a left turn
There is a small uneven hole in a cap on a part attached to the side of the compressor.Maybe it's a relief valve? We charged the ac system and it worked for a day or so. Can anybody tell me what this is?
Pulled off wiring plug at pump and no 12v there. Is there a relay involved? If so, where is it? If not, must be wiring or steering column switch. Is this multi-switch difficult to replace?