Mercedes-Benz ML320 CDI Repair and Maintenance Costs

A guide to repairs, service, and maintenance costs for your Mercedes-Benz ML320 CDI

No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
Mercedes-Benz Repair Estimates
2007 Mercedes-Benz ML320 CDI Location: Front
Brake Pad Replacement
$161 - $319
2008 Mercedes-Benz ML320 CDI Quantity: One
Glow Plug Replacement
$160 - $216
2007 Mercedes-Benz ML320 CDI Location: Rear
Brake Rotor Replacement
$536 - $726
2007 Mercedes-Benz ML320 CDI Service Detail: Front, Both
ABS Wheel Speed Sensor Replacement
$334 - $449
2008 Mercedes-Benz ML320 CDI Location: Right Side
Exhaust Manifold Gasket Replacement
$347 - $438
Repair Estimates

Never overpay. Check prices with our estimator

Mercedes-Benz ML320 CDI
to $
Mercedes-Benz ML320 CDI
to $
Mercedes-Benz ML320 CDI
to $
Mercedes-Benz ML320 CDI
to $
Mercedes-Benz ML320 CDI
to $

Mercedes-Benz ML320 CDI Problems

Transmission May not Shift into Drive Due to Failed Selector Module

The transmission drive selector module may fail resulting in the loss of gear selection capability. This condition can leave the vehicle stranded, and will require replacement of the drive selector module.

HVAC Blower Motor May Fail

The HVAC blower motor may fail. This is commonly caused by water entry through the cabin air filter areas during heavy rain or snow. Failed blower motors should be replaced. Our technicians tell us there is no special fix for this issue at this time.

The Engine May Stall or Not Start Due to a Faulty Crankshaft Sensor

The engine may stall or not start due to a failed crankshaft position sensor. Replacing the failed sensor should correct this issue.

See More Problems (4)

Mercedes-Benz ML320 CDI Questions

how should energize the position lights and fog as vehicles with key opens (1 answer)

how should energize the position lights and fog as vehicles with key opens

Do you have to have a MB brake pad when changing the pads? And Brake Wear Ind (1 answer)

I changed my Rotors and Pads because the Brake Wear indicator came on. I upgraded to Slotted & Dimpled Rotors. I didn't change the Brake Wear Indicators so I was going to have MB dealer do it and they say I have to have MB Brake pads and change the Brake Waer sensors. And want like $600 t...

Is there a separate fuse for the latching mechanism of the lift gate? (1 answer)

The lift gate functions normally but the final electric latch no longer engages, the door is fully closed and there are no obstructions.

See More Questions (23)

Mercedes-Benz ML320 CDI Recalls

Mercedes–Benz Recalls 2008 Vehicles for Defect in Power Steering Oil Pressure Driving Pin

Mercedes–Benz is recalling certain 2008 GL-Class, M-Class, and R-Class vehicles for a possible defect in the driving pin used to control power steering oil pressure. If the pin breaks during normal vehicle turning, the steering assist will no longer operate, causing difficulty operating the steering wheel. Dealers will replace the steering gear in affected vehicles.

Diesel Engine Crankshaft Sensor Failure Causes Engine Stall, No Start

The Diesel engine may stall and not restart due to a faulty crankshaft sensor. Dealers will replace the sensor free of charge to correct the problem.

See More Recalls (2)

Mercedes-Benz ML320 CDI Reviews

Still no real problems with this big car.

See More Reviews (1)