2000 Mercedes-Benz SLK230 Problem Reports

RepairPal Verified 2000 Mercedes-Benz SLK230 Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The mass air flow sensor can fail, resulting in poor fuel economy and Check Engine Light illumination.

A tube for the EGR system tends to clog with carbon buildup.

The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.

Failed spark plug wires and/or ignition coils can cause intermittent misfires (rough running); the Check Engine Light may also illuminate. Diagnoses of the ignition system will be necessary to determine which components are at fault.

Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.

The cooling system hoses may fail unexpectedly. The hoses can look good on the outside, but the rubber can degrade and erode on the inside. If not carefully checked, the hoses can burst at any time.

A coolant leak may develop from the water pump. When replacing the water pump, the drive belt tensioner should be inspected and most likely replaced as well.

Engine oil can leak into the engine wiring harness from the cam adjuster solenoid. The oil can migrate through the wires and possibly damage the engine control unit. A leaking adjuster solenoid should be replaced.

The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.

It is not uncommon for the sun visor hinges to break.

A coolant leak may develop form the Radiator due to degradation of its plastic components. Replacement of the failed radiator will be necessary.

The emissions air injection pump can seize, causing a loud squealing noise followed by smoke from the drive belt. If the engine is not turned off, the belt will break, turning on the alternator/battery warning light.

A fluid leak from the front of the vehicle may be a result of a worn steering dampening shock. Our technicians tell us that if a leak is noted from the dampening shock it should be replaced.

The anti-lock brake system (ABS) modulator assembly may fail due to dirty brake fluid. Our technicians recommend a complete brake system flush every two years in order to help prevent this problem.

One or more of the following steering linkage components may wear prematurely;  tie rod ends, drag link, or idler arm. Our technicians remind us the wheel alignment should be checked and adjusted if any of these items are replaced.