Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 1999 Mercedes-Benz SLK230 problems
A tube for the EGR system tends to clog with carbon buildup.
Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
The cooling system hoses may fail unexpectedly. The hoses can look good on the outside, but the rubber can degrade and erode on the inside. If not carefully checked, the hoses can burst at any time.
A coolant leak may develop from the water pump. When replacing the water pump, the drive belt tensioner should be inspected and most likely replaced as well.
Engine oil can leak into the engine wiring harness from the cam adjuster solenoid. The oil can migrate through the wires and possibly damage the engine control unit. A leaking adjuster solenoid should be replaced.
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
It is not uncommon for the sun visor hinges to break.
A coolant leak may develop form the Radiator due to degradation of its plastic components. Replacement of the failed radiator will be necessary.
The emissions air injection pump can seize, causing a loud squealing noise followed by smoke from the drive belt. If the engine is not turned off, the belt will break, turning on the alternator/battery warning light.
A fluid leak from the front of the vehicle may be a result of a worn steering dampening shock. Our technicians tell us that if a leak is noted from the dampening shock it should be replaced.
One or more of the following steering linkage components may wear prematurely; tie rod ends, drag link, or idler arm. Our technicians remind us the wheel alignment should be checked and adjusted if any of these items are replaced.