Problem Reports
Problem with your car? See what our experts say or submit your own.
2003 Mercedes-Benz SL500 Problems
Right Front Beam Light not working
Xenon bulb was replaced but stopped working immediately. Replace control module (ignitor) for $625 (Mercedes part) + one hour labor.
Stalling and/or "Crank no Start" Due to Failed Crankshaft Position Sensor
The engine may develop a stalling and/or no start condition due to a failed crankshaft position sensor.
Premature Tire Wear Due to Cracked Lower Control Arm Bushings
The lower control arm bushings can wear and crack, resulting excessive movement at the control arm pivot point, leading to irregular and premature tire wear. Worn Ball joints can also cause similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
Poor AC performance Due to Evaporator Temperature Sensor Failure
The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.
Early Versions of Central Gateway Module Have Software Problems
The early versions of the central gateway module (which allows different systems to communicate with each other) have software problems.
Pneumatic System Leaks May Cause Problems With Seats, Trunk, and Doors
Leaks in the pneumatic system will cause problems with the dynamic seats and the trunk and/or door closing assist.
Engine Oil Leak From PCV Vent Housing and/or Engine Inspection Plate
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
Harmonic Balancer May Fail and Damage Timing Cover
The rubber bond in the harmonic balancer can decay, which causes the balancer to move and work its way toward the timing cover. If the balancer comes into contact with the timing cover while the engine is running, it will fracture and damage the cover and potentially other surrounding parts. The harmonic balancer should be inspected at every service.
Transmission May Leak Fluid and Damage Control Module
The electrical connector at the automatic transmission may leak fluid into the wiring harness. If not repaired, the oil will migrate through the wiring harness and damage the transmission control module. At that point, a new harness and control module may be necessary to correct this problem.
ABS Modulator Failure Due to Dirty Brake Fluid
As brake fluid becomes dirty over time, it can cause a failure of the anti-lock brake system (ABS) modulator assembly. Our technicians recommend a complete brake system flush every two years to help prevent this issue.
The Differential May Develop Leaks From the Seals or Cover
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
Oil Leaking From Oil Level Sensor
An engine oil leak may develop from the oil level sensor. Replacement of the leaking sensor will commonly correct this concern.
Front Thrust Arm and Control Arm Bushing Can Crack or Tear
Front thrust arm and control arm bushings can crack and sometimes tear completely. If this is not repaired quickly, damage to the front subframe unit will occur, which is very expensive to repair. Updated control arms (that prevent damage to the subframe when the bushings wear out) are available.
Active Body Control System Can Leak Hydraulic Fluid
The active body control system can leak fluid from numerous areas, including the tandem pump, hydraulic lines, struts, and/or seals. If it is not repaired, the vehicle ride height could drop too low and cause damage to the undercarriage.