Front thrust arm and control arm bushings can crack and sometimes tear completely. If this is not repaired quickly, damage to the front subframe unit will occur, which is very expensive to repair. Updated control arms (that prevent damage to the subframe when the bushings wear out) are available.
2002 Mercedes-Benz S500 Problem Reports
Newest 2002 Mercedes-Benz S500 Problem Reports
The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.
A faulty mass air flow (MAF) sensor can cause erratic/rough engine operation and fuel economy issues. Since this sensor measures the actual amount of air entering the motor, when it fails, the engine control module (ECM) takes the wrong information and delivers incorrect volumes of fuel to the cylinders.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.
The center console armrest can break. Replacement is commonly the recommended repair.
Due to exposure to the sun, lenses for head lights may become opaque (cloudy or hazy). This reduces the effectiveness of the lights. Our technicians tell us plastic polishes can improve the clarity of the lenses, but replacement of the lamp housings is the only way to regain the full intensity of the lights.
Analog Tele Aid units are no longer supported and must be updated to digital, preferably at a dealership or a well-equipped independent shop. The update and all related factors should be completed at the same time.
Vehicles with automatic level control that ride harshly in the rear (no give in the suspension) may have one or both dampening actuators which have failed. It is commonly recommended the actuators be replaced in pairs.
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
The rubber bond in the harmonic balancer can decay, which causes the balancer to move and work its way toward the timing cover. If the balancer comes into contact with the timing cover while the engine is running, it will fracture and damage the cover and potentially other surrounding parts. The harmonic balancer should be inspected at every service.
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
CD changers, command units, voice control units, PSE units, and Tele Aid units are prone to failure, especially in early models.
Problems with the pneumatic system can cause closing assist and door lock issues.
The relay which turns the airmatic suspension pump on may fail causing the pump to run continuously. This can result in failure of the pump motor or a dead battery as the pump motor will continue to run after the car is turned off. Also, Worn airmatic pump mount bushings can causes noises in the front axle while driving on bumpy roads or a buzzing noise while the pump is running.
As brake fluid becomes dirty over time, it can cause a failure of the anti-lock brake system (ABS) modulator assembly. Our technicians recommend a complete brake system flush every two years to help prevent this issue.