The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2006 Mercedes-Benz S350 problems
The engine may develop a stalling and/or no start condition due to a failed crankshaft position sensor.
The center console armrest can break. Replacement is commonly the recommended repair.
On vehicles with airmatic suspension, the airmatic pump relay can stick, causing a dead battery, because the pump continues to operate when it should be shut off. Eventually, the pump will fail; the pump, fuse, and relay will need replacement.
Analog Tele Aid units are no longer supported and must be updated to digital, preferably at a dealership or a well-equipped independent shop. The update and all related factors should be completed at the same time.
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
The rubber bond in the harmonic balancer can decay, which causes the balancer to move and work its way toward the timing cover. If the balancer comes into contact with the timing cover while the engine is running, it will fracture and damage the cover and potentially other surrounding parts. The harmonic balancer should be inspected at every service.
CD changers, command units, voice control units, PSE units, and Tele Aid units are prone to failure, especially in early models.
Vehicles equipped with a 7-speed automatic transmission may develop a rough shifting condition, most commonly going up from first to second gear and going down from third to second or second to first gear. Our technicians tell us this is due to an internal component failure. Mercedes has released updated parts; the transmission will need to be removed and disassembled to complete the necessary repairs.
The brakes may begin to squeak at about the 50 percent wear point. This is due to the size and material used for the brake pads and rotors. The brake rotor surfaces become uneven, causing a lip to form at the outer edge. This will generally require replacement of the rotors when the pads are worn (pad life varies depending on driving style and terrain).
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
An engine oil leak may develop from the oil level sensor. Replacement of the leaking sensor will commonly correct this concern.
A door control module/actuator may fail. Our technicians recommend finding an expert to repair them. Taking the door trim panels off requires expert knowledge because they can break and the pieces are very expensive.