2003 Mercedes-Benz ML350 Problems
RepairPal has identified the most common problems with the 2003 Mercedes-Benz ML350 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
Vehicles equipped with a 7-speed automatic transmission may develop a rough shifting condition, most commonly going up from first to second gear and going down from third to second or second to first gear. Our technicians tell us this is due to an internal component failure. Mercedes has released updated parts; the transmission will need to be removed and disassembled to complete the necessary repairs.
The camshaft adjuster solenoid (which is related to the variable valve timing system) may fail or timing chain/balance shaft components may wear, resulting in illumination of the Check Engine Light and various drivability issues. Mercedes-Benz has released a service bulletin outlining specific repair instructions depending on fault codes stored.
Release cables for the rear seat (second row of seats) tend to stretch or break requiring replacement.
The brake light warning message for a burned out bulb may be displayed. Our technicians tell us the tail lamp housing may melt and distort causing a poor connection at the bulb. The lamp housing should be replaced to correct this condition.
The engine may develop a stalling and/or no start condition due to a failed crankshaft position sensor.
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
Electrical switches in the door latches can fail, causing the door locks to rapidly actuate up and down multiple times when the locks are activated by either the keyless remote or door lock switch. The affected door latch should be replaced to correct this concern.
It is not uncommon for the power steering rack to develop a fluid leak requiring replacement of the rack assembly. Loss of power steering fluid may also cause an abnormal noise and damage to the power steering pump.
A problem with the ball joints can cause a creaking noise. There is an updated part to remedy this problem.
A no start condition may develop due to an anti-theft system fault. If the drive authorization module fails to recognize the keys, the engine will not start. In many cases, a new module and keys will be needed to correct this problem.
The power steering return hose may leak at the radiator cooler fitting. If the clamp is not properly tightened, the hose can blow off, causing increased steering effort and a mess under the hood.
Motor mounts commonly fail, causing engine vibrations to be transferred to the body. Failed motor mounts should be replaced in order to prevent damage to the transmission mount.