1998 Mercedes-Benz ML320 Questions
Unanswered 1998 Mercedes-Benz ML320 Questions
Ask a Question
Our daughter said the window just went down on its own and is now broke. Can that even happen????
truck starts, will not stay running. used it to jump another car one day. it started after that. then once try starting it again, will turn over but will not stay running
my car has only done 110 k and has been serviced regularly. now after about 30 mins or 25 miles it won't accelerate above 80 km/hour. It does stop just won't go faster. Then when I stop the engine seems to be running ...
just went to start it one morning and battery was dead. i got a boost and it just turns over but will not start?? Tryed changing the crankshaft posistion sensor and still nothing. Any help would be greatly apreachia...
More detail. Had no problems this am with vehicle, went to start vehicle this afternoon, it rolled over but wouldn't start. Then after letting go of key, the key stuck in the position to start it for a few seconds ...
The automatic gear moves.
How much should a brake job cost? How much to turn rotors?
Please refer to the question above
I need cost of a tuneup for Mercedes Benz SUV 1998 ML 320
all windows worked fine, then a couple buttons broke on console switch, I ordered n replaced new console switch n now drivers n rear passengers window wont go up or down, is there a fuse that could blown or is the swi...
this problem started after it ran out of gas. And sometimes non-premium gas has been used. will the regular gas cause this type of problem, or is there a possible vacumn problem? Other issues cause this?
After driving for about 20 min on speed 40 mph i stop parked car went to court for 10 min walk out i couldnt start it , it cranks all the way and shuts down.Wont start. 15 min later starts just fine .
As I'm driving, mainly at higher speeds, 40 - 70 mph, the car loses all power. The tach drops to 5 then it dies. It's like there is a shut off swithch. I'm not sure if it is doing this when it tries to go into overdri...
Is there any picture that you could share to me because I can not pin point the location of the oil leak on my ML320 & I maintain & repair my own