The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified 1999 Mercedes-Benz E300 problems
Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
A squeak from the steering column is often related to a rubber boot in the column or a seal in the power steering rack.
The switch for the vanity mirror light above the sun visor fail; there is an updated switch for some models. On the remaining models, due to a redesign, the mirror "cassette" will need replacement.
Brake lamp housings can melt, resulting in a loss of contact for the brake light bulb holder. If this happens, the brake light will not work. Replacement of the damaged lamp housing should correct this problem.
High mileage vehicles may develop a leak from one or more of the transmission oil seals.
Instrument cluster displays tend to fail, especially the clock and gear indicators. Our technicians tell us the instrument cluster will require replacement to correct this issue.
The brakes may begin to squeak at about the 50 percent wear point. This is due to the size and material used for the brake pads and rotors. The brake rotor surfaces become uneven, causing a lip to form at the outer edge. This will generally require replacement of the rotors when the pads are worn (pad life varies depending on driving style and terrain).
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
Due to wear, high usage vehicles can experience ignition lock and tumbler failures. The ignition lock cylinder will generally require replacement to correct this concern.
The bushings for the shifter lever wear out to the point where they break and fall out. This causes excessive movement (loose feel) in the shifter lever and a clanging-type noise when changing gears.
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern.