2002 Mercedes-Benz CLK55 AMG Problem Reports
Newest 2002 Mercedes-Benz CLK55 AMG Problem Reports
The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.
The rubber bond in the harmonic balancer can decay, which causes the balancer to move and work its way into the timing chain cover. If the balancer comes into contact with the timing cover while the engine is running, it will fracture and damage the timing case and potentially other surrounding parts. The harmonic balancer should be inspected at every service.
Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
As a way to increase braking performance, the brake pads and rotors are make of a softer material and may be in need of replacement after approximately 20,000 miles; owners should be vigilant about getting their brakes checked.
A power steering fluid leak may develop from the power steering pump or the steering gearbox. Additionally the steering shock (damper) could leak its own internal fluid. Leaking components should be replaced to restore proper power steering operation.
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
The electrical connector at the automatic transmission may leak fluid into the wiring harness. If not repaired, the oil will migrate through the wiring harness and damage the transmission control module. At that point, a new harness and control module may be necessary to correct this problem.
One or more of the following steering linkage components may wear prematurely; tie rod ends, drag link, or idler arm. Our technicians remind us the wheel alignment should be checked and adjusted if any of these items are replaced.
When the engine is running, but the vehicle is not moving, a rattle heard from beneath the vehicle could indicate that one of the exhaust catalytic converters has failed. The substrate (the internal part of the catalyst that reduces emissions) can loosen and bounce around inside the canister section of the converter—the defective unit will need to be replaced. If this problem is ignored, the substrate can break down and reduce to a size that plugs the outlet pipe, which will cause a sudden loss in power.
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
An engine oil leak may develop from the oil level sensor. Replacement of the leaking sensor will commonly correct this concern.