The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.
Problems for specific Mercedes-Benz CL600 years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2001 Mercedes-Benz CL600 problems
The center console armrest can break. Replacement is commonly the recommended repair.
Analog Tele Aid units are no longer supported and must be updated to digital, preferably at a dealership or a well-equipped independent shop. The update and all related factors should be completed at the same time.
The side window glass can delaminate. If this were to occur, replacement of the affected window would be necessary.
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
CD changers, command units, voice control units, PSE units, and Tele Aid units are prone to failure, especially in early models.
Engine misfires (rough running) and lack of power are commonly caused by ignition coil pack or ignition module faults. Proper diagnoses should isolate the cause and prevent unnecessary replacement of good parts.
Due to the size and material used on the brakes of these vehicles, the brakes may start to squeak around the 50 percent wear point. The brake rotor surfaces become uneven, causing a lip to form at the outer edge of the rotor. Because of this, the rotors are usually replaced when the pads are worn (pad life varies depending on driving style and terrain).
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
The engine oil coolers may leak; Our technicians tell us removal of the cylinder heads is required to correct this leak.
A door control module/actuator may fail. Our technicians recommend finding an expert to repair them. Taking the door trim panels off requires expert knowledge because they can break and the pieces are very expensive.
The door for the vanity mirror (or the frame for the door) can break; due to a redesign, the mirror "cassette" will need replacement.
The active body control system can leak fluid from numerous areas, including the tandem pump, hydraulic lines, struts, and/or seals. If it is not repaired, the vehicle ride height could drop too low and cause damage to the undercarriage.