The mass air flow sensor tends to fail causing poor fuel economy and Check Engine light illumination. The engine air filter should be replaced when the mass air flow sensor is replaced; a dirty filter can allow debris to damage the new sensor.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2000 Mercedes-Benz C43 AMG problems
A refrigerant leak may develop from one or more of the following AC components: AC compressor, hose manifold for the compressor, or the evaporator core. The loss of refrigerant can cause poor AC performance. Our technicians tell us that proper leak diagnoses should be performed in order to determine the cause of any refrigerant loss.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.
The interior wood trim and dash pad are likely to crack due to age and sun exposure.
Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
A rear tail light housing can fail causing the brake light on the affected side to be inoperative. Replacing the failed housing is commonly required to correct this issue.
Trunk springs can break causing the trunk lid to fall back down when opened.
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
The vacuum manifold for the climate control actuator may develop a leak, This can cause poor or no operation of the air delivery and temperature control flaps.
The rubber bond in the harmonic balancer can decay, which causes the balancer to move and work its way toward the timing cover. If the balancer comes into contact with the timing cover while the engine is running, it will fracture and damage the cover and potentially other surrounding parts. The harmonic balancer should be inspected at every service.
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
A fluid leak from the front of the vehicle may be a result of a worn steering dampening shock. Our technicians tell us that if a leak is noted from the dampening shock it should be replaced.