1997 Mercedes-Benz C230 Questions
Get answers to questions about your 1997 Mercedes-Benz C230 at RepairPal. Find solutions, diagnose problems and get back on the road.Refine by vehicle
I got a quote with a range but i DON'T SEE were the shops are. To call them
I have a tire/wheel off the front, and am curious if I need to remove the 13mm bolt on the rear of the caliper bracket to remove the pad. Or, am I making it too difficult? Often a car simply has a spring retainer. I do not see such on this car.
The battery on my mercedes was disconnected and replaced ,afterwards my security light would not stop blinking and my radio shows the word WAIT and wont turn on. The car opperates fine other than that. how do i reset my radio? thank you for your time and expertise.
Anyone ever used regular unleaded in this car and what was the experience.
Car has an automatice transmission. It's stuck in 1st gear.
Looks like I have an input/turbine speed sensor A circuit malfunction and an input speed circuit malfunction. How much will it cost to have this fixed. Additionally, looks like I will have to replace the single windsheild wiper transmission as well. How much will this cost?
1997 BENZ C230 I JUST BOUGHT THIS CAR IT STARTS AND SHUTS DOWN RIGHT AWAY WHATS WRONG
where is it
These are the codes that were found on my check engine light.I replaced the mass air flow 2 mo ago and I replace the EGR valve. It is still stalling out when idling. It is like it gets too hot and shuts down. I also noticed that if I turn my AC down the idle goes up.
P0 170 FUEL SYSEM TRIM MALFUNCTION BANK 1
P0 100 MASS OR VOLUME AIR FLOW CIRUCUIT MALFUNCTION
P0 400 REPLACED EGR DIDNT FIX THE PROBLEM
P1519 Adjustable Camshaft Timing Solenoid
I replaced the mass air flow sensor 2 months ago.
I replaced the EGR valve and it is still stalling at redlights...could it be something else?
None of the needles move when I turn the car on. I don't know how fast I am going or how much gas is in the car. Is this an electrical problem or a fuse problem?
my car started shaking like i had put bad gas in it. now it has a popping sound when i try to start it and when i put it in gear it stops running.the check engine like is also on. does anybody know what this problem could be???
The fuses have been changed several times and upgraded from 15 amp to 20 amp and they keep blowing everytime you cut the car off and start it back up. These fuse regulate
my gas gauge and speedometer and other gauges.Can you tell me what the problem is?
First time replacement at 70k miles. Owned car for 2 years, bought at 30k miles. I replaced the water pump 1 day ago (Monday). Removed belt with no problem and no tensioner? issue...it just slipped off ok.
BUT trying to put it back on is a no go.
How does it get back onto the pulleys? Do I need a special tool? Do I need to monkey with a tensioner. Is the tensioner the smooth idler on the top right of the engine? What gives??? Thanks
how do i change the ignition switch and cylinder.
My car was stalling out when I was at redlights and now it is stalling in the middle of the road for no reason. My mechanic thinks it is the ignition. I just had the catalitic converter fixed, not sure if the 2 are related. I did have the tumbler replaced last year so it could be that too. Any idea's?