Problem Reports
Problem with your car? See what our experts say or submit your own.
1990 Mercedes-Benz 350SDL Problems
Bad Switch/Blower Motor Resistor Assembly May Cause Inoperative Heater Blower Motor
Other than a defective motor, a bad switch or blower motor resistor assembly can cause an inoperative heater blower motor.
"No start" Caused by Failed Fuel Pump/Relay
The fuel pump and/or fuel pump relay can fail, causing the car to crank over but not start. Proper diagnoses will be necessary to confirm if the pump or relay is at fault.
Climate Control System Problems Due to Wear in Climate Control Buttons Contacts
The climate control system can fail or perform erratically due to internal problems with the climate control button electrical contacts. Replacement of the climate control assembly is commonly required to correct this problem.
Power steering hoses can develop leaks
Power steering hoses and components can develop leaks.
AC Not Cold Due to Leaking Hose
A refrigerant leak may develop from one or more of the AC hoses. Proper leak detection procedures should be followed if refrigerant loss in encountered. Replacement of any leaking hoses will we required to restore proper AC operation.
Transmission Oil Seals May Leak on High Mileage Vehicles
High mileage vehicles may develop a transmission fluid leak from one or more of the oil seals.
Fluid Leak From Front of Vehicle
A worn steering dampening shock can cause a fluid leak at the front of the vehicle. If a leak is noted from the dampening shock, our technicians tell us that it should be replaced.
Instrument Cluster, Turn Signal/Wiper Combination Switch May Fail
The instrument cluster, along with the turn signal and wiper combination switch, can fail.
ABS Modulator Failure Due to Dirty Brake Fluid
As brake fluid becomes dirty over time, it can cause a failure of the anti-lock brake system (ABS) modulator assembly. Our technicians recommend a complete brake system flush every two years to help prevent this issue.
Excess Free Play in Steering and/or Alignment Issue
The tie rod ends, idler arm, and/or drag link components of the steering linkage may wear prematurely. Please keep in mind the wheel alignment should be checked and adjusted when any of these items are replaced.
Improper Temperature Output From HVAC
One or more blend door vacuum actuators may fail resulting in the incorrect output temperature from the HVAC system. Failed actuators will require replacement to restore proper HVAC operation.
Squeaking/Worn Brake Pads May Require Rotor Replacement Also
The brakes may begin to squeak at about the 50 percent wear point. This is due to the size and material used for the brake pads and rotors. The brake rotor surfaces become uneven, causing a lip to form at the outer edge. This will generally require replacement of the rotors when the pads are worn (pad life varies depending on driving style and terrain).
The Differential May Develop Leaks From the Seals or Cover
Leaks may develop from the differential seals and/or cover on older or high mileage vehicles. Our technicians recommend a complete reseal of the differential unit when these leaks are addressed.
High Usage Vehicles May Experience Ignition Lock and Tumbler Failures
Due to wear, high usage vehicles can experience ignition lock and tumbler failures. The ignition lock cylinder will generally require replacement to correct this concern.
Shifter Lever Bushings May Break Causing Loose Feel/Noise
The bushings for the shifter lever wear out to the point where they break and fall out. This causes excessive movement (loose feel) in the shifter lever and a clanging-type noise when changing gears.