Problem Reports
Problem with your car? See what our experts say or submit your own.
1990 Mercedes-Benz 300SEL Problems
Bad Switch/Blower Motor Resistor Assembly May Cause Inoperative Heater Blower Motor
Other than a defective motor, a bad switch or blower motor resistor assembly can cause an inoperative heater blower motor.
Premature Tire Wear Due to Cracked Lower Control Arm Bushings
The lower control arm bushings can wear and crack, leading to irregular and premature tire wear. Worn Ball joints can also cause similar tire wear problems. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
"No start" Caused by Failed Fuel Pump/Relay
The fuel pump and/or fuel pump relay can fail, causing the car to crank over but not start. Proper diagnoses will be necessary to confirm if the pump or relay is at fault.
Coolant Hoses May Fail Unexpectedly
The cooling system hoses may fail unexpectedly. The hoses can look good on the outside, but the rubber can degrade and erode on the inside. If not carefully checked, the hoses can burst at any time.
Climate Control System Problems Due to Wear in Climate Control Buttons Contacts
The climate control system can fail or perform erratically due to internal problems with the climate control button electrical contacts. Replacement of the climate control assembly is commonly required to correct this problem.
Check Belt Tensioner When Replacing Water Pump
A coolant leak may develop from the water pump. When replacing the water pump, the drive belt tensioner should be inspected and most likely replaced as well.
Motor Mounts Fail and Cause Vibration in Body
Motor mounts commonly fail, causing engine vibrations to be transferred to the body. Failed motor mounts should be replaced in order to prevent damage to the transmission mount.
AC Not Cold Due to Leaking Hose
A refrigerant leak may develop from one or more of the AC hoses. Proper leak detection procedures should be followed if refrigerant loss in encountered. Replacement of any leaking hoses will we required to restore proper AC operation.
Rough Running Engine Due to Misfire
A rough running motor or lack of power can be caused by a failed distributor cap or rotor, ignition wires (or their resistors), or valve cover gasket leaks. If the valve cover gasket leaks, oil can pool where the ignition wire resistor connects to the spark plug. The resistor can fail and the spark plug may not fire because of a short circuit through the oil.
Coolant Leak/Overheating Due to Radiator Leak
A coolant leak may develop form the Radiator due to degradation of its plastic components. Replacement of the failed radiator will be necessary.
Transmission Oil Seals May Leak on High Mileage Vehicles
High mileage vehicles may develop a transmission fluid leak from one or more of the oil seals.
Noise and/or Smoke From Drive Belt Area
The emissions air injection pump can seize, causing a loud squealing noise followed by smoke from the drive belt. If the engine is not turned off, the belt will break, turning on the alternator/battery warning light.
Fluid Leak From Front of Vehicle
A worn steering dampening shock can cause a fluid leak at the front of the vehicle. If a leak is noted from the dampening shock, our technicians tell us that it should be replaced.
Instrument Cluster, Turn Signal/Wiper Combination Switch May Fail
The instrument cluster, along with the turn signal and wiper combination switch, can fail.
ABS Modulator Failure Due to Dirty Brake Fluid
As brake fluid becomes dirty over time, it can cause a failure of the anti-lock brake system (ABS) modulator assembly. Our technicians recommend a complete brake system flush every two years to help prevent this issue.