It is not uncommon to encounter premature failure of the anti-lock brake system (ABS) modulator assembly due to dirty brake fluid. Our technicians recommend flushing the brake fluid every two years in order to help prevent this problem.
1991 Mercedes-Benz 300E 4MATIC Problem Reports
Newest 1991 Mercedes-Benz 300E 4MATIC Problem Reports
One or more of the following steering linkage components may wear prematurely; tie rod ends, drag link, or idler arm. Our technicians remind us the wheel alignment should be checked and adjusted if any of these items are replaced.
Internal and External engine oil & coolant leaks can develop from the head gasket and/or timing cover gasket; these leaks should be repaired before the engine oil and coolant intermix which can result in severe engine damage.
One or more blend door vacuum actuators may fail resulting in the incorrect output temperature from the HVAC system. Failed actuators will require replacement to restore proper HVAC operation.
Due to the size and material used on the brakes of these vehicles, the brakes may start to squeak around the 50 percent wear point. The brake rotor surfaces become uneven, causing a lip to form at the outer edge of the rotor. Because of this, the rotors are usually replaced when the pads are worn (pad life varies depending on driving style and terrain).
High mileage or older vehicles commonly develop leaks from the differential seals and/or cover. Our technicians recommend a complete reseal of the differential unit whenever these leaks are repaired.
The engine wiring can degrade because the insulating material falls off leaving the bare wire exposed. This can cause many problems depending on which wires are exposed and what they touch.
Due to wear, high usage vehicles can experience ignition lock and tumbler failures. The ignition lock cylinder will generally require replacement to correct this concern.
The bushings for the shifter lever wear out to the point where they break and fall out. This causes excessive movement (loose feel) in the shifter lever and a clanging-type noise when changing gears.
A vibration felt through the center floor of the vehicle can be caused by driveshaft flex discs, which crack and shred, causing excessive driveshaft movement. Not repairing these can cause damage to the driveshaft center support bearing, or, in the worst case scenario, damage to the transmission or differential.