McKay's Automotive-Cypress

"I'm glad that you are aware of the difference between a drain and fill Transmission service and a complete Transmission flush.
The drain and fill requires about 5 quarts, costing less due to less f..."

"Do you hear the motor running? Did you inspect the track to see if something is stuck in the seats track like a coin or some other obstruction?
There a few other possiblities but one should bring t..."

"There are too many things that can go wrong with A/C systems, the best thin to do is have a reputable shop look at it and give you a proper Diagnoses/est.
If you need this diagnosed properly you ca..."

"You Have to take the door panel off to gain access to the glass.
If you need this diagnosed properly you can call one of our four stores @
1) Willowbrook (281) 890-9400 3) The Woodlands (281) 465-..."

"PO 449 would be related to the Evap system, vent solinoid control curcuit.
This may be a soft code (Symptom but not the problem) not a hard code (one of the actual problems). One should properly di..."

"When you say "it runs hot" do you know if the engine is really hot or are you going by the gauges?
I would like to perform a check to the cooling system to deturmine if there is a leak or a blockag..."

"Do you know where it is leaking from? From the Pump, Hoses etc...
If you brought it to one of our shops, we could find out exactly where the leak is coming from and give you an estimate to repair t..."

"If I'm reading this right, you poss. have two different problems, one Rack and Pinion and one Transmission.
What makes you think that the Rack and Pinion needs to be replaced?
Are you sure that th..."

"On your vehicle, there is no Dipstick, if your transmission is leaking fluid, you may want to get that inspected.
If you need this diagnosed properly you can call one of our four stores @
1) Willo..."

"Some vehicles are a little more difficult then others, if you don't have a spring compressor and the proper tools, you may not get the job done properly.
If you need this repair done properly you c..."

"On certain vehicles, there are seperate control units for each side of the car which can contribute to the blend doors not opening or closing.
If you need this diagnosed properly you can call one o..."

"This vehicle would be a good choice because they are very dependable and the maintenance & brake work is right in line with other common makes & models. You should have many years of trouble free d..."

"It depends upon which one it is (right or left) Each converter is made into the exhaust manifold. Please feel free to contact us for an estimate. 281-304-7833."

"This vehicle is not equipped with an EGR valve. "

"The p0121 on the monte carlo is a throttle position fault. More testing would be needed to determine if the sensor is actually bad. The p0420 on the mercury is a catalytic converter fault. Most li..."

"Be careful and check this engine out very carefully for a blown cylinder head gasket. They will have a slight problem but will continue to cause overheating and ultimately damage the engine"

"Either your accelerator pedal has broken or if you have a "drive by wire" model it could bel a throttle actuator fault."

"The air diaphragm will leak and will not support the vehicle properly. It will lean to one side or squat in the rear. Also, they can leak down overnight an the vehicle will be sitting too low."

"These two fault codes are associated with your vehicles emissions system and the proper operation of the system. unfortunately, more diagnostics will be required to find out exactly what needs to b..."

"Mercon V Fords synthetic fluid is the specification. Usually any synthetic will meet the minimum requirememts."

"The blend door is most likely not working properly and is not allowing the air to flow through the evaporator. "

"It definitley sounds like an actuator is not working properly. The passenger side actuator is quite a bit more expensive than the drivers due to the labor involved.
Diagnosis would have to be done..."

"Check the main connecto on the back of the radio and make sure it is seated completely. It should have a clip that "snaps" into place to lock it."

"It should just pop right out of an indention in the pad itself. Usually if you replace the brake pad, you replace the sensor as well."

"Going to need ALOT more information to answer this one :)"