»

Car Recalls

Recalls are issued for cars with safety-related defects or problems

Mazda recalls

 

For Models: Mazda MAZDASPEED6, Mazda MPV, Mazda Mazda6, Mazda RX-8

Body, Interior & Misc., June 19, 2014

RepairPal Expert Overview:

This limited regional recall is for vehicles currently registered or first sold in Florida, Puerto Rico, Hawaii and the U.S. Virgin Islands, and equipped with Takata-brand air bag inflators. Upon deployment the driver and/or passenger airbag inflator could rupture, increasing the risk of personal injury. Mazda dealers will replace the affected airbag inflator modules to correct this concern.

For Models: Mazda Mazda6

Body, Interior & Misc., September 24, 2013

RepairPal Expert Overview:

Three screws attach each door latch, over time these screws can loosen. If the latch screws loosen excessively the door latch may not engage correctly, the door could open unexpectedly while the vehicle is in motion, increasing the risk personal injury or an accident. Dealers will add a thread locking compound and re-torque the latch mounting bolts to correct this concern.

For Models: Mazda Mazda6, Mazda RX-8

Body, Interior & Misc., April 11, 2013

RepairPal Expert Overview:

Airbags use a chemical reaction contained in an inflator module to create the pressure necessary to inflate the bags when deployment is required. These vehicles are being recalled because the front passenger airbag inflator may produce excessive internal pressure when deployed and as a result, the inflator module could rupture, causing metal fragments to strike vehicle occupants. Dealers will inspect and replace any defective passenger front airbag inflator module found.

For Models: Mazda Tribute

Engine, July 26, 2012

RepairPal Expert Overview:

Mazda Tribute models equipped with a V6 engine are being recalled because inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost fully depressed. This risk exists regardless of whether or not the speed control (cruise control) is used.

A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could result in a crash. Dealers will correct this concern by increasing the engine cover clearance. Remedy parts are expected to be available in mid-August. Until then, dealers will disconnect the speed control cable as an interim remedy if parts are not available at the time of an owner's service appointment. The Mazda recall number is 6812G.

 

For Models: Mazda Tribute

Brakes, January 19, 2012

RepairPal Expert Overview:

The brake master cylinder reservoir cap can leak brake fluid. Leaking brake fluid can come in contact with the antilock brake system (ABS) module wiring harness. As a result, corrosion can develop in the module electrical connector, which can cause the connector to melt, smoke, or possibly catch fire. Dealers will replace the brake master cylinder reservoir cap and modify the ABS electrical system to correct this concern. The Mazda recall number is 6712A.

For Models: Mazda MAZDASPEED3, Mazda Mazda3

Body, Interior & Misc., June 15, 2011

RepairPal Expert Overview:

The ground terminal of the windshield wiper motor may have been bent during vehicle assembly. Due to the bent terminal, over time, the electrical resistance of the motor circuit may increase to the point that the windshield wipers may stop working. Loss of wiper function in adverse weather could increase the risk of a crash. Dealers will install an additional ground harness on the wiper motor to correct this concern. This recall is expected to begin by July 15, 2011. The Mazda recall number is 6411F.

For Models: Mazda Mazda6

Exhaust & Emissions, February 25, 2011

RepairPal Expert Overview:

A spider web can cause a restriction in the EVAP canister vent line. This can result in undue stress on the fuel tank during the vapor purge function of the EVAP system. This stress could crack the fuel tank, resulting in a leak. Any fuel leak increases the risk of a fire. Dealers will inspect and clean the vent line and install a spring to keep spiders from entering the line. This recall is expected to begin on March 25, 2011. The Mazda recall number is 6211B.

For Models: Mazda Mazda5

Exhaust & Emissions, November 24, 2010

RepairPal Expert Overview:

Mazda is recalling 2009–2010 Mazda 5 models due to moisture in the fuel pump electrical connector, which may result in corrosion and connector pin failure. Pin failure may cause stalling or a no-start condition. Dealers will inspect the fuel pump connector and repair or replace the affected wire harness if necessary.

For Models: Mazda Mazda3, Mazda Mazda5

Suspension & Steering, September 15, 2010

RepairPal Expert Overview:

Mazda is recalling 2007–2009 Mazda 3 and Mazda 5 vehicles due to a sudden loss of power steering assist that can occur at any time. A sudden loss of power steering assist adversely affects the driver's ability to steer the vehicle, increasing the risk of a crash. Starting in September 2010, Mazda will mail notification letters to owners with information about the recall.

For Models: Mazda CX-9

Heating & Air Conditioning, March 9, 2010

RepairPal Expert Overview:

The heated seat elements may overheat, causing a fire hazard. Dealers will install an additional ground harness on the seat heater control system. If any damage has already occurred, those parts will be replaced or repaired, too. This recall began on March 9, 2010. The Mazda recall n umber is 5810B.

Ask a Question
More about this car