X

Mazda MX-6 Recalls

Models : Ford Probe, Mazda 626, Mazda MX-6, Subaru XT
Engine, September 27, 2005
Summary:CERTAIN SPX FILTRAN FUEL FILTERS WITH A 45-DEGREE ANGLE INLET TUBE, MODEL 800F350-S1, SOLD AS REPLACEMENT FILTERS FOR 1993-1997 FORD PROBE,1993-2001 MAZDA 626 AND MX-6, AND 1983-1994 LOYAL, 3-DOOR COUPE, HATCHBACK, SEDAN, WAGON, BRAT, DL, GL, GL-10, RX, XT, AND XT6 PASSENGER VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. CERTAIN SPX FILTRAN FUEL FILTERS WITH A 90-DEGREE ANGLE INLET TUBE, MODEL 800F300-S2, SOLD AS REPLACEMENT FILTERS FOR 19983-1994 SUBARU VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. FUEL MAY LEAK FROM THE FILTER DUE TO NON-CONFORMING BRAZING WELDS WHERE THE INLET TUBE IS CONNECTED TO THE FILTER CAN.
Models : Mazda 626, Mazda MX-6
Electrical & Lights, April 7, 2000
Summary:VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE HEADLIGHT WIRE THAT RUNS THROUGH THE TURN SIGNAL LEVER CAN FAIL AT THE POINT WHERE IT IS SOLDERED TO THE HEADLIGHT SWITCH.
Models : Mazda 626, Mazda MX-6
Drive Train, September 3, 1999
Summary:THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE SPEEDOMETER GEAR SET CAN FAIL. SYMPTOMS INCLUDE AN INOPERATIVE SPEEDOMETER, SEVERE LACK OF POWER, AND/OR A TRANSMISSION WHICH STAYS IN THIRD GEAR. IN SOME CASES, THE "OD OFF" LIGHT MAY ALSO FLASH.
Models : Mazda 626, Mazda MX-6
Body, Interior & Misc., January 4, 1999
Summary:VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH THE SAS SENSOR UNIT. THESE VEHICLES CAN EXPERIENCE AIR BAG DEPLOYMENTS IN MINOR UNDERCARRIAGE IMPACTS.
Models : Mazda 626, Mazda MX-6
Engine, November 20, 1998
Summary:VEHICLE DESCRIPTION: PASSENGER VEHICLES. AN EXTERNAL SPRING IN THE TIMING BELT TENSIONER CAN BREAK AND GET CAUGHT IN THE TIMING BELT.
Models : Ford Probe, Mazda 626, Mazda MX-6
Brakes, September 30, 1993
Summary:THE GROOVE FOR THE REAR WHEEL BEARING RETAINER RING WAS INCORRECTLY MACHINED.
Models : Mazda MX-6
Suspension & Steering, March 25, 1992
Summary:THE LOWER ARM BALL JOINTS ON BOTH SIDES OF THE FRONT SUSPENSION MAY NOT HAVE BEEN TORQUED TO SPECIFICATION.