2003 Mazda Mazda6 Questions

Answered 2003 Mazda Mazda6 Questions

Ask a Question
View:RecentAnsweredUnanswered
Ok, there are two things that went wrong, that lead to my mazda not starting. the gas gauge started reading a quarter tank when completely run out of gas. then a few weeks later it read 1-1/2 quarter tank of gas when...
When I started by car this am, the engine sputters for a bit then stalls after 20-30 seconds. Also, when I press on the gas it doesn't "rev" at all. Is it something with the transmission??
I own a 2003 2.3L European JMZGG 166HP Hatchback Mazda 6. My engine's nikasil coating is damaged after putting chrome plated piston rings in 1000 miles. I'm willing to avoid this problematic engine with its balanc...
This shop i went to said it would be 870 to 900 bucks...is that a rip off?
Yesterday, I started it and turn it off, started it and turned it off, tryed to restart it again but it wouldn't. The gauges began to quiver and flutter and go up and down for a minute or so. After that, they went ba...
only code po303 #3 can shut off in gear usaly fix it not always i am broke down on road now if somebody can tell me what to do to get it going home to a permanet fix
I just got this car, and I chose the 4cyl. because it's NOT the timing chain rattling, oil-leaking v-6...however every where I look at forums and personal posts, the shitty front wheel bearings are mentioned. Your web...
and the codes po340 and po128 keep returning. the engine surges a little and at hwy miles mph 65 to 70 the rpms go crazy but nothing major drivibility wise. can someone please help???
While driving the it felt like it wasnt getting any gas and would shake and felt boggled down till I hit second gear. Had engine light code read and said it was spark plugs. Replaced them and engine light went off. La...
No code is showing up.I changed mass air sensor.It will idle but when you put in drive it starts missing and it will go about 10mph and when you try to give it gas it just misses and sputters.
the pulsation occurs when applying brakes to stop and the check engine light is on or it blinks on and off.
AND flywheel def. has some teeth missing. Would that be the main cause of problem or could it be the problem is with bendix and once that is replaced it will still run with the missing teeth on flywheel?
My car started making a grinding noise sometimes when I tried to crank it, and would take several times to crank. It became worse and worse until it just wouldn't crank at all one day.A man at the gas station heard it...
have to warm car up for 20 mins before it kicks in drive beside that the car runs like a race car