» » »

Problems for specific Mazda Mazda3 years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Most reported 2006 Mazda Mazda3 problems

 

Verified for the Mazda Mazda3

A Loose rear stabilizer bar link can cause a rattling noise from the rear suspension while driving on rough roads. Our technicians tell us if the rear stabilizer bar and links are not found to be loose, there are updated sway bar bushings available which should correct this problem.

36 Reports
Me Too

Verified for the Mazda Mazda3

A vibration felt at 55 mph may not be a tire problem. Mazda has revised motor mounts available which may help remedy this problem.

26 Reports
Me Too

Verified for the Mazda Mazda3

The rear brakes can squeak because the rear brake pad may be contacting the brake rotor. A burr on the backing plate of the brake pad can prevent the pad from seating in the bracket properly causing the contact with the rotor. The backing plate and the pad support hardware can be deburred in the contact areas. Mazda has also released revised brake pads.

19 Reports
Me Too

Verified for the Mazda Mazda3

Damaged wiring to the seat belt pre-tensioner sensor may cause the Airbag Warning Light to illuminate.

14 Reports
Me Too

Verified for the Mazda Mazda3

Internal failure of the ignition switch may create a condition where the key reminder continues to chime even though the key is removed. In addition, the doors cannot be locked with the keyless entry system. Replacing the ignition switch with an updated switch is the typical repair.

12 Reports
Me Too

Verified for the Mazda Mazda3

The engine may be difficult to start in extremely cold weather (-20F) after a short trip. This can be caused by sticking main relay points.

11 Reports
Me Too

Verified for the Mazda Mazda3

If the steering effort feels heavy, this can be caused by a power steering fluid leak. Some models may have burrs on the return port of the power steering reservoir that create a gap between the hose and the port. Sanding the burrs off the port and replacing the power steering return hose is the repair for this concern.

7 Reports
Me Too
Ask a Question