after i put trans back on the clutch pedal when foot off it wont come back up it'll stay dow...
Q&A
Ask Your QuestionAll 1990 Mazda B2200
Question
How to repair the leak on the engine block ?
I would like to change the cylinder head gasket and I need a diagram on how to do it and I could ...
Question
Replaced O2 sensor for a bosch new one. Since then i've got check engine light.
The old O2 sensor didnot give me check engine light.But the new one did it twice then turns off w...
Question
Have a 1990 Mazda b2200 with a rear main oil seal leak and ticking in the head?
Truck was running fine tell I redid all the front gaskets than developed a tick in the head had i...
Question
My truck didnot pass smog test for the second time.
The first smog test became bad,but most of the error were fixed.Today got the second smog test,ev...
Question
how to get the rpm and timing right without accelerating the engine too much??
put a ground wire from the green test connector.Set the rpm to 750 on idle and timing on 6. As so...
Question
FAIL smog check it says: PCV:fail,Fuel Evaporative Controls Functional:fail.....
Any idea how to solve the problem??? Already replaced pcv valve.Bought new gas tank cap. Any ide...
Question
had smog check done,didnot pass.pcv valve fail,presure in gas tank didnot pass !
what should I do to fix this ??
Question
got a leak in the heater core and want 2 know if it is difficult to remove it ?
just bypass the heater core cause a leak inside the truck
Question
want to add power steering system to my truck.Can I use 1 from an ext.cab b2600?
is it worth it ? or not ?
Question
ignition switch not going back to the lock position,why ???
even trying hard just stays in the ACC position
Question
just replaced whole clutch set and didnt mark pressure plate w flywheel
how can i make sure i installed it the right way?
Question
Does the ABS hydraulic Valve Assembly have anything to with stopping your truck?
If you can only stop your truck by pumping the brake peddle three to four times, does that indica...
Question
my truck has had a complete brake system done due to all the parts were ruined.
brake fluid that brake system was filled with power steering fluid when having a oil change. brka...
Question
engine code reads coolant temp senser, but replaced 3 times, code still pops up.
the truck is really hard to start up in the morining mostly have to push the gas pedle all the wa...
This week's top 10
| 1 globalhelper | 6 FREDDY BLUE |
| 2 pushrod | 7 gearhead89 |
| 3 ziptie12 | 8 tdtoolbox |
| 4 ChevyASE | 9 wenyan |
| 5 csubak30 | 10 ebans777 |