malfunction light on 2008 Chrysler Pacifica

Hi my pacifica malfunction light keeps comming on and off. Why it is doing that?

by in Saint Paul, MN on April 14, 2011
1 answer
ANSWER by on April 14, 2011
If it comes on steady and stays on then its a sensor problem more than likely but if it blinks while youre driving take it in IMMEDIATELY!!! you will do severe damage if you wait.. I hope this helps. It is supposed to come on everytime you start the vehicle then go off after a couple seconds but if it stays on then you need to have it checked.
Related Items:
Since my vehicle turned 56000 (on the dot), my Pacifica's Malfuction Indicator Light has been coming on. It stays on for a trip, then goes off the next. It has done it three times now. I have check...
the waring light came on i looked in the owner manual and it says malfunction when i had retuned from going out i turned off the car and a few min later it began making a noise like the starter was...
my radio and lights work. is it my starter or alternator? could it be a chip malfunction? or do I just need a whole new motor?
Are there typical engine codes that would flag based on the car mileage (87000)?

Related Content