The steering motor sensor may fail, resulting in loss of power steering assist from the electric power steering system. Dealers will check the power steering control module (PSCM) for any trouble codes and replace the steering gear for vehicles that have codes relevant to the concern stored. If no codes are found, dealers will update the PSCM software free of charge to resolve the concern.
For vehicles located in cold weather states where road salt and other contaminants may be present on the road, the mounting bolts for the power steering gear motor may corrode and break. As a result the motor could detach from the steering gear. This would result in a loss of power steering assistance, and make turning the steering wheel more difficult than usual. Dealers will apply sealer to prevent corrosion, and will replace affected bolts as necessary.
A component within a door latch can break making the doors difficult to latch when closed. This could cause the driver and/or passenger to believe their door is secure when it is not. A door that is not latched properly could open unexpectedly while driving, increasing the risk of personal injury and property damage. Dealers will replace all four door latches free of charge to correct this concern.
The vacuum pump relay may overheat, causing a vehicle fire hazard. Dealers will replace the vacuum pump relay free of charge to resolve the problem.
These vehicles have been recalled because their interior door handles may fail to return to their stowed position after use. In the event of a side impact, the door may unlatch, increasing the risk of injury. Dealers will inspect all four interior door handles and either repair or replace them free of charge.
Because of a manufacturing issue, the fuel pump may fail prematurely due to improper nickel plating of certain internal components. If the fuel pump were to fail the engine would stall, increasing the risk of a crash. Dealers will replace the fuel pump on affected models to correct this concern.
The Push-to Start/Stop button may be pushed inadvertently causing the engine and vehicle to turn off unexpectedly and the vehicle to stop, increasing the risk of a crash. If a crash were to occur with the vehicle off the airbags and seatbelt restraints may not function as intended, increasing the risk of injury. Dealers will relocate the Push-to Start/Stop button and reprogram the Powertrain Control Module to correct this concern.
Certain vehicles are being recalled because the upper intermediate steering shaft could separate resulting in loss of steering control. This recall includes models previously recalled under campaign #13V-385, these vehicles may have been incorrectly repaired. Dealers will inspect and replace the upper immediate shaft if necessary. If the steering column lower bearing has separated, a retainer clip will be installed.
Corrosion due to salt exposure on the fuel tank can lead to a fuel leak in affected vehicles. Near an ignition source, leaking fuel can catch fire and endanger passengers and property. Ford has not yet developed a remedy but will correct the issue when the remedy has been finalized.
The Restraint Control Module (RCM) is the "brains" behind the airbag system. Portions of the module are coated to help prevent moisture intrusion. The coating can crack and when exposed to humidity the printed circuit board may short circuit. This could cause one or more of the airbag system components not to function as expected in the event of a crash, increasing the risk of personal injury. Replacement parts are currently not available, a second notification letter will be sent when they are and dealers will perform the necessary repairs.