X

Lexus GS300 Recalls

RepairPal Expert Overview:

Due to the remnants of anti-corrosion plating, a fuel leak may develop from where the fuel pressure sensor is attached to the fuel delivery pipe. Any fuel leak always increases the risk of a fire. Dealers will clean and reseal the area of the fuel pressure sensor to correct this concern.

 

Models : Lexus GS300, Lexus GS350
Body, Interior & Misc., February 24, 2011
RepairPal Expert Overview:

The plastic pad embedded in the floor carpet may interfere with the operation of the accelerator pedal. As a result, it may become stuck in a partially open position. A stuck accelerator can result in unintended vehicle speed, increasing the risk of a crash. Dealers will modify the plastic pad in the floor carpet. No owner notification schedule has be set at this time.

RepairPal Expert Overview:

The fuel pressure sensor monitors fuel pressure for optimum engine performance and emission controls. Lexus has found that some of these sensors can loosen from the fuel line, which may cause the sealing gasket to leak fuel. To prevent this from occurring in the future, your Lexus dealer will ensure that these sensors are properly fastened. No schedule of owner notification is available at this time.

RepairPal Expert Overview:

Ethanol fuels with a low moisture content will corrode the internal surface of the aluminum fuel delivery pipes. As the condition progresses, the Check Engine Light may illuminate and/or a fuel leak could develop under the hood. Any fuel leak increases the risk of a fire. Dealers will inspect and replace the fuel delivery pipes as necessary. This recall is expected to begin during February 2009. The Lexus recall number is 9LA.

Models : Lexus GS300, Lexus GS430, Lexus IS250, Lexus IS350
Engine, December 15, 2007
RepairPal Expert Overview:

Mechanical stress on two fuel pipes in the engine compartment, combined with the presence of corrosive agents in the fuel, can result in a crack in the fuel line. A fuel leak can result, increasing the risk of a fire. Dealers will replace the two suspect fuel lines with redesigned parts to correct this concern. The Lexus recall number is 7LC.

Models : Lexus GS300, Lexus GS430, Lexus IS250, Lexus IS350
Body, Interior & Misc., April 21, 2006
RepairPal Expert Overview:

The front seat belt retractors may not release due to a failure of the emergency locking system. If the seat belt is locked, the occupant may not be able to properly fasten the seat belt. An unrestrained occupant may have an increased risk of injury in the event of a crash. Dealers will replace the front seat belt assemblies to correct this concern.

 

RepairPal Expert Overview:

On 133 vehicles, certain airbag inflators were assembled with an insufficient amount of the heating agents necessary for proper airbag deployment.  In the event of a crash, if the airbag does not deploy as expected, the risk of injury will increase. Dealers will replace only the suspect airbags to correct this concern. The Toyota recall number is 60B. The Lexus recall number is 6LB.

Models : Lexus GS300
Suspension & Steering, June 21, 1999
Summary:VEHICLE DESCRIPTION: PASSENGER VEHICLES. DUE TO INADEQUATE LUBRICATION OF THE INSIDE OF THE LOWER BALL JOINTS, EXCESSIVE WEAR CAN OCCUR CAUSING DAMAGE TO THE LOWER BALL JOINTS. SEPARATION OF THE LOWER BALL JOINTS FROM THE STEERING KNUCKLE ARMS COULD OCCUR.
Models : Lexus GS300, Lexus GS400
Suspension & Steering, June 17, 1998
Summary:VEHICLE DESCRIPTION: PASSENGER VEHICLES. DUE TO A MANUFACTURING DEFECT OF THE YAW RATE SENSOR FOR THE VEHICLE STABILITY CONTROL (VSC), THE VSC CAN OPERATE IMPROPERLY IF THE SENSOR IS AFFECTED BY CERTAIN ELECTROMAGNETIC WAVES, SUCH AS FROM A CELLULAR PHONE.
Models : Lexus GS300
Suspension & Steering, April 28, 1995
Summary:THE SPHERICAL PORTIONS OF CERTAIN LOWER BALL JOINTS HAD FINISHED SURFACES THAT WERE NOT SMOOTH CAUSING FRICTION WITH THE SURFACE OF THE BALL JOINT CAP.