A water leak may develop from the sunroof area. The is commonly caused by kinked or pinched sunroof drains. Our technicians tell us the drain tubes should be inspected and correctly routed to correct this issue.
2006 Land Rover Range Rover Problem Reports
RepairPal Verified 2006 Land Rover Range Rover Problem Reports
A clunk type noise may be noted while turning left or right at slow speeds. Our technicians tell us this noise is commonly caused by the intermediate steering shaft, a revised intermediate shaft is available to correct this concern.
The parking brake may develop a screeching noise or fail to release. Our technicians tell us the is commonly caused by the parking brake cable being out of adjustment or failure of the parking break actuator. Cable adjustment and/or actuator replacement would be necessary to correct this concern.
Black smoke from the exhaust, poor acceleration, and/or a rough engine idle may be a result of corrosion affecting the exhaust gas recirculation (EGR) valve operation. Replacement of the faulty EGR valve would be required to correct this issue.
A pulsation may be noted upon brake application. This condition is commonly caused by warped brake rotors. Our technicians recommend inspecting both front and rear brake rotors when this condition occurs. Brake pads should be replaced along with any warped rotors to correct this condition.
In severe wet conditions, water may enter the anti-lock brake system (ABS) modulator electrical connector resulting in corrosion and illumination of the ABS warning light. Our technicians tell us revised modulator ground leads are available to better seal the connector. If corrosion is found in the electrical connector the connector will need to be repaired as necessary and the new ground leads installed.
The automatic transmission may exhibit a harsh downshift from second to first gear. Our technicians tell us that updated transmission control module software is available to correct this concern.
The check coolant warning light may illuminate if the incorrect engine coolant mix or type is used. The coolant/water mixture should be kept at the 50/50 ratio for proper warning light operation. Additionally, if the incorrect type of coolant is used, cylinder head and cooling system damage may result.
A chirping type noise may be noted from the engine area, mostly at idle. This type of noise is generally caused by a faulty drive belt idler pulley. Our technicians tell us a revised pulley is available to correct this concern. Chirping Type Noise From Engine at Idle