1996 Land Rover Range Rover Problem Reports

Newest 1996 Land Rover Range Rover Problem Reports

Report A Problem

Oil leaks from the valve cover gaskets are not uncommon. Our technicians tell us that if one valve cover seal is found leaking both valve covers should be resealed to try and avoid future issues.

A pulsation may be noted upon brake application. This condition is commonly caused by warped brake rotors. Our technicians recommend inspecting both front and rear brake rotors when this condition occurs. Brake pads should be replaced along with any warped rotors to correct this condition.

In severe wet conditions, water may enter the anti-lock brake system (ABS) modulator electrical connector resulting in corrosion and illumination of the ABS warning light. Our technicians tell us revised modulator ground leads are available to better seal the connector. If corrosion is found in the electrical connector the connector will need to be repaired as necessary and the new ground leads installed.

An oil leak may develop from the front crankshaft seal. Our technicians tell us a revised seal is available which should correct this concern.

An oil leak may develop from the oil pan area. This may be caused by improper sealing of the oil pan "through" bolts. Our technicians tell use that revised "patch" bolts and sealing procedures are available to correct these leaks.

A rough or unstable idle may be noted due to an intake manifold vacuum leak. Our technicians tell us a revised intake manifold gasket, along with manifold bolt flat washers which will better distribute the clamping force are available to correct this concern.