knock sensor location on 2000 Chevrolet Monte Carlo

check engine light is on. check codes and it was the knock sensor code

by in Springfield, OH on August 27, 2010
1 answer 4 comments
ANSWER by on August 27, 2010
dont be so quick to replace the sensor. lots of connector problems
COMMENT by on August 27, 2010
i have just replace plugs and wires. could i have done something? where should i start?
COMMENT by on August 27, 2010
the knock sensor is on the back side of the block on passenegr side. take a look and make sure you did not knock the wire off. Roy
COMMENT by on August 28, 2010
i will go take a look today. THANKS
COMMENT by on August 28, 2010
found the knock sensor! there are two sensors. one is on the backside of the engine in the middle under the exhaust manifold. the other is in the front directly opposite the one in the rear. did'nt have to replace, wire was knock off. THANKS for heads up and info. i have a 3.8 engine. the 3.1 and 3.4 only have one sensor.
Related Items:
we know where the knock sensor is...can't quite figure the best way (least invasive) to approach and replace it...have a diagram, but it's not helping....can you give us an A,B,C hint as to how to ...
i have blinking and sometimes steady oil light on but oil pressure seems to be o k no rattles or knocks

Related Content