Should I contact Kia Canada and ask for my car to be included in the recall??
Q&A
Ask Your QuestionAll 2006 Kia Sorento
Question
induction control valve making noise. Recall on 2003-05 but not on 06.
Question
My kia sorento 2006 kept on shutting down by itself.
Diagnosis shows different result every time engine was checked (diagnosed) by the mechanic. For e...
Question
My A/C blows hot air. Was told the clutch is out.
Do I need a whole new compressor or can the clutch be replaced? Thanks
Question
Part numbers ac clutch.
I need the new and improved part numbers.
Question
How long does it take for a cleaning additive to work? Should I use synth oil?
Oil presuure light went on. Shop did a pressure test. Oil pressure on low half of block ok. Passa...
Question
Oil pressure light goes on after about 10 minutes of driving.
Just had an oil change and problem occured shortly thereafter. Oil levels appear to be fine. 74k ...
Question
kia that shimmys?
my 2006 kia sorento shimmys when i first turn a corner, more so when i turn right?
Question
how to install a clutch kit on a 2006 kia sorento
the clutch slips when pulling off in first gear generally with a load, and sometimes in other ge...
Question
I was told that i would need the oil pan to be dropped and engine cleaner run
...to clean out sludge from engine.What should it cost?
Would i be better of having them take ap...
Question
Is the ingnition coils on my 2006 KIA sorento on the drivers side of the engine
I need to replace one engine coil, I recently had the other two of the three coils replaced by a...
Question
Is it necessary to change the pully's and tensioner when A/C compressor goes?
My car makes this sqeaking sound, took it into the shop, they said the A/C compressor was out and...
Question
why wont my 2006 kia sorento heat up
when you turn it on it just blows cold air
Question
02 oxygen sensor, where is bank 1,2,3 & 4 located?
Where is bank 1,2,3,& 4 located for the 06 Kia Sorento?
Question
60000 miles service cost?
need 60000 miles service-
Question
putting timing belt on, need to know postion for cyclinders to be correct.
Cyclinder postions when putting timing belt on
-
Verified
Quality Work -
Guaranteed
Fair Prices -
Happy
Customers
This week's top 10
| 1 globalhelper | 6 csubak30 |
| 2 pushrod | 7 wenyan |
| 3 ziptie12 | 8 goodguy |
| 4 ChevyASE | 9 tdtoolbox |
| 5 gearhead89 | 10 Jamesw |