key ignition issue on 1990 Buick LeSabre

ok the key broke in the ignition the part is inexpensive enough to get but how do i change it out??

by in Mesa, AZ on September 23, 2009
2 answers 1 comment
ANSWER by on September 23, 2009
It is not very easy to change the ignition lock cylinder on your 1990 Buick LeSabre and there are some special tools required. It may be wise to leave this one to the professionals.
1 person likes thisFlag inappropiate
COMMENT by on May 22, 2011
its easy just unscrew the screws behind the steering wheel get special tool frm autozone screw the tool from autozone screw it in holes in steering wheel and pull it out by twisting special tool it will come straight out it should be a black plate after that then pull out signal plate the your ingnition should slide out or just call me and i can coach u threw it 315 6793833 have a good 1
ANSWER by on May 22, 2011
get special tool from autozone for steering wheel take screws out behind steering wheel take special tool and twist it up with screw on da special tool it will come wright off behind that black plate and there it is
Related Items:
ok the key broke in the ignition the part is inexpensive enough to get but how do i change it out??
Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and igni...
The security warning light comes on most of the time when turning the key to engage the starter. When that happens the key has to be left on for several minutes until the light goes out and the car...
Security light blinking and car will start by starter and go right back dead
turn key every thing shuts off headlight are bright and stay on will not crank battery is good all connections are clean