Q&A

2007 Jeep Wrangler

Question: jeep wrangler o2 sensor

• O2 sensors, stalling, won't start on first try
  I have a problem with my second O2 sensor on the catalytic converter, it keeps on getting high voltage, I've replaced the sensor three times and its the same problem. I've looked over the wiring an...

  Q&A > Jeep > 1999 Jeep Wrangler

• jeep runs fine....but i hear a slight rattling noise.. could this be serious.
  replaced o2 sensor because of check engine light.and obd diagnosstic code ...resent repairs manifold gasket....tightened heat shield....exhaused checked...could this be a loose hardtop ....noise is...

  Q&A > Jeep > 1997 Jeep Wrangler

• I have a 97 jeep wrangler 2.5 eng. It sputters occasionally
  sputters when accelerating and sometimes while at a cruise or constant speed. I have replaced distributer, cap, button all plugs, and wires. I replaced the fuel pump a weed ago and it seemed to fi...

  Q&A > Jeep > 1997 Jeep Wrangler

• 06 jeep wrangler, starts and idles fine, will only rev to ~2500 rpm
  then it start dropping off until it about 1000 rpm. no engine codes. you can pull the fuel pump relay and it dies almost immediately,. is it the fuel pump or what?

  Q&A > Jeep > 2006 Jeep Wrangler

• what causes a jeep to hesitate on highway between 50-60 mph
  when driving on highway every time u hit about 50-60 mph and it will hesitate then u step on the gas ang spped up and it seems to be ok... have already replaced plugs and wires no lights come on d...

  Q&A > Jeep > 2004 Jeep Wrangler