2013 Jeep Wrangler Problems

RepairPal has identified the most common problems with the 2013 Jeep Wrangler as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
Choose your vehicle
Known Problems

Water can leak near the A-pillar, at the front edge of the driver and passenger side doors. An improved seal is available.

Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.

Loose or worn suspension and steering components can cause a wobble or shaking in the steering wheel. It may happen at a certain speed and subside as the vehicle accelerates through the range. Tire balance can contribute to this as well.

A Check Engine Light may illuminate indicating a "Cylinder #3 Misfire." This normally occurs in hot weather after the vehicle has been driven, parked for ten to twenty minutes, and then restarted. Heat from the exhaust vaporizes fuel inside the #3 fuel injector and causes the misfire. Installing an insulator sleeve normally lowers the temperature enough so the fuel will not vaporize.

The throttle position sensor (TPS) may fail causing intermittent drivability problems like hard starting, stalling, and/or hesitation when accelerating. A failed TPS will require replacement, proper diagnoses should always be performed before replacing any parts.

Some models are susceptible to rear main oil seal failures in dirty or dusty conditions. As dirt and dust collect on the oil seal, the abrasion wears through the sealing surface. A spacer is used between the bell housing and engine that has a small slot in the 12 o'clock position. Filling this slot with RTV silicone and cleaning the seal area can help prevent damage to the seal.

A no crank or no start condition may develop due to electronic lockup of the wireless control module (WCM), also referred to as the Sentry Key Remote Entry Module (SKREEM). When this module fails the remote keyless entry system will also not operate. The WCM is commonly replaced to correct this concern.