A no crank or no start condition may develop due to electronic lockup of the wireless control module (WCM), also referred to as the Sentry Key Remote Entry Module (SKREEM). When this module fails the remote keyless entry system will also not operate. The WCM is commonly replaced to correct this concern.
Problems for specific Jeep Wrangler years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2008 Jeep Wrangler problems
Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.
Loose or worn suspension and steering components can cause a wobble or shaking in the steering wheel. It may happen at a certain speed and subside as the vehicle accelerates through the range. Tire balance can contribute to this as well.
Water can leak near the A-pillar, at the front edge of the driver and passenger side doors. An improved seal is available.
Due to warped front brake rotors or variations in the thickness of the rotors, brake pulsations may develop. The best method to reduce pulsations is to use an "On the Car" brake lathe (as long as the rotors are suitable for turning). "On the Car" equipment can correct variations (or "runout") in the rotor surfaces because it also corrects variations in other components (e.g. the hub).