had rear bearings checked... fine..brakes fine.. has made for quite a while....back tires kinda h...
Q&A
Ask Your QuestionAll 2000 Jeep Wrangler
Question
usually when turning but always on take off makes a loud grinding sound ????
Question
I have a transfer case leak where it bolts to trans. what part is causingincase
tranny is not losing fluid just transfer case
Question
The engine is running hot.
I took it to a shop and they changed the radiator and thermostat but it still runs hot. It now ha...
Question
How to disconnect the rear axle junction block? Whats the procedure?
I need to remove my rear axle assembly. 2000 Jeep Wrangler Sahara. My Chrysler manual states &quo...
Question
Can you adjust the valves on a jeep wrangler 2008 v-6 3.8L THE VALVES LOUD
VALVES ARE MAKING NOISE AND NEED TO BE ADJUSTED
Question
diagnostic test and found issue with lock up torque converter, costly to repair?
Tech performed test, said it could also be low reverse over running one way clutch. suggested dea...
Question
I have a new 4WD switch. should it be in 4wd when installing or removing ?
is it on the driverside of transfer case.
Question
i need to replace motor seals...is there any website where free schematics to be
need free schematics and repair intructions
Question
When I Hit a bump and the jeep will shake uncontrollably
Whenever I hit a bump the jump shakes so bad I have to pull over to gain control of the vehicle. ...
Question
Jeep is losing power and making clicking/clunking sound upon accel.
4 cylinder 2.5 Manual. Recently replaced the radiator, spark plugs, distributor cap and rotor, an...
Question
DONUT GASKET 2000 JEEP WRANGLER
MY 2000 JEEP WRANGLER RECENTLY FAILED INSPECTION.THE INSPECTOR SAID I NEEDED A NEW DONUT GASKET.W...
Question
computer crash
what is the cause of a cumputer to go bad on this jeep
Question
How do you check the fan resister to see if it's good
My HVAC fan worked intermittently for a short time and then quit all together. Fan resister? or F...
Question
need valve adjustment specs and actions that go with it, if any, thanx.
knocking noise from engine, especially after the engine gets warm.
Question
REAR END STABLELIZER ON DRIVERS SIDE WELD BROKEN
THE REAR END DRIVERS SIDE STABLIZER BAR THAT IS WELDED TO THE THE REAR AXLE WELD BROKE OFF REAR A...
-
Verified
Quality Work -
Guaranteed
Fair Prices -
Happy
Customers
This week's top 10
| 1 globalhelper | 6 csubak30 |
| 2 pushrod | 7 FREDDY BLUE |
| 3 ziptie12 | 8 gearhead89 |
| 4 ChevyASE | 9 ebans777 |
| 5 wenyan | 10 tdtoolbox |