2000 Jeep Wrangler Questions
Answered 2000 Jeep Wrangler Questions
Ask a Question
as the vehicle is being stopped the brake is applied and when the clutch pedal is pressed down the rpm's go from 1000 to 2000 rpms. I replaced the air control sensor what else could cause this problem.
5 speed manual transmission jumps out of first gear
Started one day, wouldn't start the next. Had this problem before, so I replaced the fuel pump. Cleaned the fuel tank while it was out. Still won't start. Fuel pressure good at pressure bleed valve.
I understand that this is a overflow/drain tube for the A/C, but I go throught alot of coolant because it drain out of this tube. what would cause this?
Blower for ac/heater only works on highest speed
Condensate drips from the drain under the hood, I've tried blowing air & routing-out with a soft bristle brush. I get tiny pieces of Styrofoam & filings from aluminum & plastic out? A/C is on when the leak occurs. W...
I know its overflow line. Should water come out like a faucet running?
Freon was leaking from my AC. The shop put a dye in to isolate the leak and when I brought it back told me I needed a new AC Receiver Drier, needed to fix a couple of seals at the end of some hoses, and replace a shra...
When i get to the stop sign or stop light and i have my foot on the brake and take it off to put it on the gas pedal it does this jerking motion.
tranfer case, leaking oil thru the seal, is that the pinon seal. what is the fix? Thanks Mike
had rear bearings checked... fine..brakes fine.. has made for quite a while....back tires kinda hop when it makes the noise...dont hear while driving...just starting to drive..grinding,,crunching sound
I took it to a shop and they changed the radiator and thermostat but it still runs hot. It now has a miss and my mechanic says the head my need work. Any other ideas?
I need to remove my rear axle assembly. 2000 Jeep Wrangler Sahara. My Chrysler manual states "remove the brake lines at the rear axle junction block" See Section 5 Brakes for more info. Its all crimp fittings on the h...
need free schematics and repair intructions
Whenever I hit a bump the jump shakes so bad I have to pull over to gain control of the vehicle. It shimmy all over the road.