When normal alignment practices do not bring components into the alignment specifications, offset upper ball joints are available.
1997 Jeep Wrangler Problem Reports
RepairPal Verified 1997 Jeep Wrangler Problem Reports
If water leaks into the passenger compartment and under the passenger side carpet, an heating, ventilation and AC (HVAC) drain hose is available.
Jeep issued an emissions recall in late 2006 to update the powertrain control module (PCM) software on certain 1997 - 1998 vehicles. As part of the recall, the catalytic converter will also be inspected for damage and replaced as necessary. To see if your vehicle is included in the recall you can visit the Jeep website (owners' section) that allows owners to input their VIN number and check the recalls on their vehicle.
The AC evaporator may freeze after extended use of the air conditioner. The output may feel low due to the restricted evaporator. Once the ice buildup melts, the AC operates normally. A revised low pressure cycling switch is available which may fix this concern.
A ticking type noise may be noted from the engine area due to an exhaust manifold that has cracked where the pipes are welded; cracked manifolds should be replaced.
The throttle position sensor (TPS) may fail causing intermittent drivability problems like hard starting, stalling, and/or hesitation when accelerating. A failed TPS will require replacement, proper diagnoses should always be performed before replacing any parts.
Loose or worn suspension and steering components can cause a wobble or shaking in the steering wheel. It may happen at a certain speed and subside as the vehicle accelerates through the range. Tire balance can contribute to this as well.
The throttle body may accumulate an oily, black residue in the bore and on the throttle plate causing hard starting or possibly stalling when coming to a stop. The throttle body should be cleaned during regular maintenance but do not spray cleaners directly on or at the throttle position sensor (TPS) as this can damage the sensor.
Some models are susceptible to rear main oil seal failures in dirty or dusty conditions. As dirt and dust collect on the oil seal, the abrasion wears through the sealing surface. A spacer is used between the bell housing and engine that has a small slot in the 12 o'clock position. Filling this slot with RTV silicone and cleaning the seal area can help prevent damage to the seal.
Water can leak near the A-pillar, at the front edge of the driver and passenger side doors. An improved seal is available.
Due to warped front brake rotors or variations in the thickness of the rotors, brake pulsations may develop. The best method to reduce pulsations is to use an "On the Car" brake lathe (as long as the rotors are suitable for turning). "On the Car" equipment can correct variations (or "runout") in the rotor surfaces because it also corrects variations in other components (e.g. the hub).
A loud buzzing or whining when the transmission is in reverse may be caused by a regulator valve in the transmission valve body. A revised valve was released that does not resonate. Careful diagnosis should be performed because other causes can create the noise.