1995 Jeep Wrangler Problems

RepairPal has identified the most common problems with the 1995 Jeep Wrangler as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
14
Known Problems

Ignition wire failures can cause a rough idle or intermittent engine misfire and there might not be a Check Engine light.

Loose or worn suspension and steering components can cause a wobble or shaking in the steering wheel. It may happen at a certain speed and subside as the vehicle accelerates through the range. Tire balance can contribute to this as well.

The throttle position sensor (TPS) may fail causing intermittent drivability problems like hard starting, stalling, and/or hesitation when accelerating. A failed TPS will require replacement, proper diagnoses should always be performed before replacing any parts.

Engine oil leaks from the valve cover gasket, oil pan gasket and timing cover gasket are common.

Some models are susceptible to rear main oil seal failures in dirty or dusty conditions. As dirt and dust collect on the oil seal, the abrasion wears through the sealing surface. A spacer is used between the bell housing and engine that has a small slot in the 12 o'clock position. Filling this slot with RTV silicone and cleaning the seal area can help prevent damage to the seal.

A ticking type noise may be noted from the engine area due to an exhaust manifold that has cracked where the pipes are welded; cracked manifolds should be replaced.

Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.

The outer exhaust manifold studs can break and cause exhaust leaks, commonly noted as a ticking type noise. The outer studs, clamps, and nuts will need to be replaced and are now being tightened to a reduced torque value (20 Nm/180 in lbs).

If a growling noise can be heard from the AC compressor while the AC is on, a revised compressor is available which should correct this problem.

The throttle body may accumulate an oily, black residue in the bore and on the throttle plate causing hard starting or possibly stalling when coming to a stop. The throttle body should be cleaned during regular maintenance but do not spray cleaners directly on or at the throttle position sensor (TPS) as this can damage the sensor.

Due to warped front brake rotors or variations in the thickness of the rotors, brake pulsations may develop. The best method to reduce pulsations is to use an "On the Car" brake lathe (as long as the rotors are suitable for turning). "On the Car" equipment can correct variations (or "runout") in the rotor surfaces because it also corrects variations in other components (e.g. the hub).

Internal leaks in the speed sensor or speed sensor gear adapter (speedometer adapter) are common. A revised speed sensor (white in color, old versions are black), used in production since November of 1993, solves the problem. If leaks develop between the sensor and the adapter or between the adapter and the transmission housing (transfer case if 4WD), a revised speedometer adapter is available.

The tailgate hinges can corrode making it difficult to open the tailgate.

The hood support rod can rattle against the radiator driving over rough roads or when the doors are slammed. Installing a foam ring on the support rod can help to prevent the rattling.