jeep won't turn over on 1999 Jeep Wrangler

Went to start my jeep this morning, would not turn over. Starter good, battery good. What else could it be?

by in Paige, TX on March 06, 2011
2 answers
ANSWER by on March 06, 2011
ignition switch, neutral safety switch, battery cable(s) for a few.
ANSWER by on May 11, 2011
Could be Crankshaft Position Sensor (CPS), had one go out on my 99 Jeep Wrangler and thought battery was completely dead at first, no crank. It is located on top of the bell housing of the transmission. Access through engine compartment to see part and go from underneath to unbolt wire harness. Easy fix!
Related Items:
my 99 jeep wrangler started but then back fired, so my son turned it off now it turns over but won't start acts like its not getting enough fuel to start, can anyone give me any suggestions on what...
Have a 1992 Jeep Wrangler with 246K miles. 4.0L (6 cyl), manual. On a trip, ran ~150 miles, filled tank w/about 9 gallons of gas, tried to start car and would not start. Have in w/ mechanic now....
have replaced plugs,wires,dist-cap and rotor button,new fuel pump assembly. still won't start.And yes tested coil and resistance is within range....can you test the throttle position sensor and cou...
My girlfriend was driving her jeep when all of a sudden the engine died. Now the engine turns over fine but no sign of it starting. Heard about replacing crank sensor but it's 70 dollars and didn't...

Related Content