2011 Jeep Liberty Problem Reports
Most Reported 2011 Jeep Liberty Problem Reports
An engine misfire at idle (rough idle), accompanied by illumination or flashing of the Check Engine Light, could indicate a problem with one or more of the intake valves. Revised intake valves & valve locks are available to address this concern.
Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Low fluid level in the differential or transfer case can result in bearing failure. Damaged bearings commonly cause a whine or growl type noise.
The sky slider sunroof may not open. A software upgrade for the control module is available which should correct this concern.
If the power door locks are buzzing or are intermittently noisy, a new door latch assembly may solve this. The door lock actuators are integrated into the latch assemblies.
A no crank or no start condition may develop due to electronic lockup of the wireless control module (WCM), also referred to as the Sentry Key Remote Entry Module (SKREEM). When this module fails the remote keyless entry system will also not operate. The WCM is commonly replaced to correct this concern.
A water leak may develop from the "flipper" glass. Our technicians tell us that installing an adhesive liner and flipper glass seal should correct this concern.