If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.
Problems for specific Jeep Grand Cherokee years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2009 Jeep Grand Cherokee problems
Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.
Software updates are available to solve various Check Engine Light and warning light related issues.
Due to warped front brake rotors or variations in the thickness of the rotors, brake pulsations may develop. The best method to reduce pulsations is to use an "On the Car" brake lathe (as long as the rotors are suitable for turning). "On the Car" equipment can correct variations (or "runout") in the rotor surfaces because it also corrects variations in other components (e.g. the hub).
Vehicles with manual temperature control may develop a condition where warm air is coming from the instrument panel outlets when cold has been selected. Our technicians tell us a revised air distribution housing is available to correct this concern.
The power right side rear view mirror may not adjust correctly. Our technicians tell us a revised mirror assembly is available which can correct this concern.
Check Engine Light With Any or All of The Following Codes: P2302, P2305, P2308, P2311, P2314, P2317, P2610
The fuel tank may become hard to fill and/or the fuel fill nozzle may shut off repeatedly while fueling. Our technicians tell us that various items including the fuel tank, vapor recirculation tube, fuel fill tube, or EVAP system canister control valve may be at fault. Proper diagnoses will be required to determine the exact cause of this concern.
A popping or groan type noise may occur when opening or closing one or more of the vehicle doors. This may be caused bu insufficient lube on the lower hinge roller axle. Applying a small amount of grease between the roller pin and the inside surface should correct this concern. Our technicians tell us if the grease is not applied in the correct location, the noise will remain.