A Check Engine Light may illuminate indicating a "Cylinder #3 Misfire." This normally occurs in hot weather after the vehicle has been driven, parked for ten to twenty minutes, and then restarted. Heat from the exhaust vaporizes fuel inside the #3 fuel injector and causes the misfire. Installing an insulator sleeve normally lowers the temperature enough so the fuel will not vaporize.
Problems for specific Jeep Grand Cherokee years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2003 Jeep Grand Cherokee problems
Offset upper ball joints are available for when normal alignment practices do not bring components into the alignment specifications.
If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.
Temperature blend and recirculation doors commonly fail, which can cause the AC modes not to change or the temperature to be different on the left and right sides. If replacing blend air doors, a recirculation door, a door link, or a sub-assembly housing, new heating, ventilation and AC (HVAC) sub-assemblies are available that improve reliability.
Electrical contacts in the tail lamp housing tend to break or melt, which can cause the brake lights to fail or work intermittently. Complete inspection of the tail light housing and bulbs is recommended before replacing any parts.
The AC/heater (HVAC) system may unexpectedly switch to the defrost mode when accelerating. This system is operated by engine vacuum and should be inspected for any vacuum leaks if this problem develops. There is also a revised vacuum check valve available to address this concern.
Jeep issued an emissions recall in late 2006 to update the powertrain control module (PCM) software on certain 1996 vehicles. As part of the recall, the catalytic converter will also be inspected for damage and replaced as necessary. To see if your vehicle is included in the recall you can visit the Jeep website (owners' section) that allows owners to input their VIN number and check the recalls on their vehicle.
Failure in the blower motor power module (automatic temperature controls) or resistor block (manual AC) may cause the heater blower motor to work only on the high setting. The connector to the power module/resistor block is known to overheat (and sometimes melt). The connector or terminals should be replaced; a replacement connector is available.
A broken seat heater element located in the seat cover may make the seat heater inoperative. The condition usually occurs in the seat bottom; two repair kits are needed for each seat.
Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.
Loose or worn suspension and steering components can cause a wobble or shaking in the steering wheel. It may happen at a certain speed and subside as the vehicle accelerates through the range. Tire balance can contribute to this as well.
On January 17th I took my car in because I went to the gas station after leaving home got my gas went in to pay for my gas came out and my car would not start. Tried starting it 15 times and finally it started. Took it into the dealership and they said that the battery was bad so I replaced it. Today left my home vehicle started. I got to the gas station again shut the car off locked it came back out within 20 minutes and it would not start ...
Due to warped front brake rotors or variations in the thickness of the rotors, brake pulsations may develop. The best method to reduce pulsations is to use an "On the Car" brake lathe (as long as the rotors are suitable for turning). "On the Car" equipment can correct variations (or "runout") in the rotor surfaces because it also corrects variations in other components (e.g. the hub).